Laboratory of Water Physics and Membrane Processes, Faculty of Chemistry and Chemical Engineering, University of Maribor, 20000, Maribor, Slovenia.
Department of Inorganic Chemistry and Technology, National Institute of Chemistry, 1000, Ljubljana, Slovenia.
Appl Biochem Biotechnol. 2023 Nov;195(11):6768-6789. doi: 10.1007/s12010-023-04416-x. Epub 2023 Mar 15.
Probiotics are live microorganisms that can have beneficial effects on humans. Encapsulation offers them a better chance of survival. Therefore, nozzle-free electrospinning was introduced for their embedding in nanofibrous material. Probiotic Lactobacillus paragasseri K7 in lyophilized and fresh form, with and without inulin as prebiotic, was added to a polymer solution of sodium alginate (NaAlg) and polyethylene oxide (PEO). Conductivity, viscosity, pH, and surface tension were determined to define the optimal concentration and volume ratio for smooth electrospinning. The success of the formed nanoscale materials was examined by scanning electron microscope (SEM), while the entrapment of probiotics in the nanofibrous mats was detected by attenuated total reflection-Fourier transform infrared spectroscopy (ATR-FTIR) and X-ray photoelectron spectroscopy (XPS). Spontaneous diffusion of bacteria from electrospun samples in PBS buffer pH 7.4 was studied by plate counting on MRS agar. By exposing polymer solutions containing L. paragasseri K7 and inulin to a high electric field, the nanofilm was formed on a polypropylene substrate, used as collecting material. When polymer solutions without inulin were used, the bead-like nanofibers may have become visible. The SEM results suggest that inulin, in addition to K7 strain, additionally lowers the conductivity of spinning macromolecular solution and hinders the nanofiber formation. The results of ATR-FTIR confirmed the presence of L. paragasseri K7 embedded in nanocomposites by the appearance of characteristic peaks. The samples containing the probiotic regardless of its form with inulin had similar surface composition, except that the sodium content was higher in the samples with fresh probiotic, probably due to greater and thus less easy embedding of the bacteria in NaAlg. Within 2 h, the largest amount of probiotic strain K7 was spontaneously released from the electrospun sample containing the inulin and probiotic in freeze-dried form (44%), while the amount released from the nanofibrous sample, which also contained the inulin and probiotic in fresh form, was significantly lower (21%). These preliminary results demonstrate the potential of nozzle-free electrospinning technology for the development of probiotic delivery systems for short-term use, such as feminine hygiene materials (tampons, pads, napkins).
益生菌是能够对人类产生有益影响的活体微生物。包封可以提高它们的生存机会。因此,引入无喷嘴静电纺丝技术将其嵌入纳米纤维材料中。冷冻干燥和新鲜形式的益生菌副干酪乳杆菌 K7,以及含有菊粉的和不含有菊粉的作为益生元,被添加到藻酸钠(NaAlg)和聚氧化乙烯(PEO)的聚合物溶液中。通过测定电导率、粘度、pH 值和表面张力来确定用于顺利静电纺丝的最佳浓度和体积比。通过扫描电子显微镜(SEM)检查形成的纳米级材料的成功,而通过衰减全反射傅里叶变换红外光谱(ATR-FTIR)和 X 射线光电子能谱(XPS)检测益生菌在纳米纤维垫中的包埋。通过在 pH 7.4 的 PBS 缓冲液中对电纺样品中的细菌进行平板计数来研究细菌从电纺样品中的自发扩散。通过将含有 L. paragasseri K7 和菊粉的聚合物溶液暴露于强电场中,纳米薄膜在用作收集材料的聚丙烯基底上形成。当使用不含菊粉的聚合物溶液时,可能会出现珠状纳米纤维。SEM 结果表明,除了 K7 菌株之外,菊粉还会降低纺丝高分子溶液的电导率,并阻碍纳米纤维的形成。ATR-FTIR 的结果通过特征峰的出现证实了 L. paragasseri K7 嵌入纳米复合材料中的存在。含有益生菌的样品,无论其形式是否含有菊粉,其表面组成都相似,除了含有新鲜益生菌的样品中的钠含量较高,这可能是由于更多的细菌,因此更难以嵌入到 NaAlg 中。在 2 小时内,含有菊粉和冷冻干燥形式的益生菌的静电纺丝样品中释放出的益生菌菌株 K7 的量最大(44%),而含有菊粉和新鲜形式的益生菌的纳米纤维样品中释放出的量则明显较低(21%)。这些初步结果表明,无喷嘴静电纺丝技术具有开发用于短期使用的益生菌输送系统的潜力,例如女性卫生材料(卫生棉条、护垫、卫生巾)。