Ferruti Paolo, Alongi Jenny, Barabani Emanuele, Manfredi Amedea, Ranucci Elisabetta
Dipartimento di Chimica, Università degli Studi di Milano, Via C. Golgi 19, 20133 Milano, Italy.
Polymers (Basel). 2023 Apr 13;15(8):1871. doi: 10.3390/polym15081871.
Polyamidoamine hydrogels prepared by the radical post-polymerization of α,ω-bisacrylamide-terminated M-AGM oligomers, in turn obtained by the polyaddition of 4-aminobutylguanidine with -methylenebisacrylamide, were reinforced with raw silk fibers, which can establish covalent bonds with the polyamidoamine matrix via reaction of the amine groups in the lysine residues with the acrylamide terminals of the M-AGM oligomer. Silk/M-AGM membranes were prepared by impregnating silk mats with M-AGM aqueous solutions and subsequent crosslinking by UV irradiation. The guanidine pendants of the M-AGM units imparted the ability to form strong but reversible interactions with oxyanions, including the highly toxic chromate ions. The potential of the silk/M-AGM membranes to purify Cr(VI)-contaminated water down to the drinkability level, that is, below 50 ppb, was tested by performing sorption experiments both in static (Cr(VI) concentration 20-2.5 ppm) and flow conditions (Cr(VI) concentration 10-1 ppm). After static sorption experiments, the Cr(VI)-loaded silk/M-AGM membranes could easily be regenerated via treatment with a 1 M sodium hydroxide solution. Dynamic tests performed using two stacked membranes and a 1 ppm Cr(VI) aqueous solution reduced Cr(VI) concentration down to 4 ppb. Remarkably, the use of renewable sources, the environmentally friendly preparation process, and the goal achieved meet eco-design requirements.
通过α,ω-双丙烯酰胺封端的M-AGM低聚物的自由基后聚合制备的聚酰胺胺水凝胶,该低聚物又通过4-氨基丁基胍与亚甲基双丙烯酰胺的加成聚合得到,用生丝纤维增强,生丝纤维可通过赖氨酸残基中的胺基与M-AGM低聚物的丙烯酰胺末端反应与聚酰胺胺基质建立共价键。通过用M-AGM水溶液浸渍丝垫并随后通过紫外线辐射交联来制备丝/M-AGM膜。M-AGM单元的胍侧基赋予了与氧阴离子形成强但可逆相互作用的能力,包括剧毒的铬酸根离子。通过在静态(Cr(VI)浓度为20 - 2.5 ppm)和流动条件(Cr(VI)浓度为10 - 1 ppm)下进行吸附实验,测试了丝/M-AGM膜将受Cr(VI)污染的水净化至可饮用水平(即低于50 ppb)的潜力。静态吸附实验后,负载Cr(VI)的丝/M-AGM膜可通过用1 M氢氧化钠溶液处理轻松再生。使用两个堆叠的膜和1 ppm Cr(VI)水溶液进行的动态测试将Cr(VI)浓度降低至4 ppb。值得注意的是,使用可再生资源、环保的制备过程以及实现的目标符合生态设计要求。