Department of Chemistry, Faculty of Arts and Sciences, Manisa Celal Bayar University, 45140, Manisa, Turkey.
Bioprocess Biosyst Eng. 2023 Aug;46(8):1147-1162. doi: 10.1007/s00449-023-02887-0. Epub 2023 Jun 3.
In this study, inorganic-based carrier perlite (PER) and cyclodextrin-modified perlite (PER-CD) were used for Subtilisin Carlsberg (SC) immobilization. For enzyme immobilization, the supports aminated with 3-aminotriethoxysilane were first activated with glutaraldehyde (GA) and genipin (GE), and then, the immobilized enzymes (PER-SC and PER-CD-SC) were obtained. The reaction medium for SC immobilization consisted of 500 mg carrier and 5 ml (1 mg/ml) enzyme solution. The immobilization conditions were pH 8.0, 25 °C, and 2 h incubation time. Free and immobilized SC were used for transesterification of N-acetyl-L-phenylalanine ethyl ester (APEE) with 1-propanol in tetrahydrofuran (THF). The transesterification activity of the enzyme and the yield of the transesterification reaction were determined by gas chromatography (GC). 50 mg of immobilized or 2.5 mg of free SC was added to the reaction medium, which was prepared as 1 mmol APEE and 10 mmol alcohol in 10 mL of THF. The conditions for the transesterification reaction were 60 °C and 24 h of incubation. The structure and surface morphology of the prepared carriers were characterized using scanning electron microscopy (SEM) and thermogravimetric analysis (TGA). Casein substrate was used in the optimization study. The optimum temperature and pH for SC activity were found to be 50 °C and pH 8.0, respectively, for free and immobilized SC. The thermal stability of immobilized SC was found to be greater than that of free SC. At the end of 4 h of exposure to high temperature, the immobilized enzyme maintained its activity at approximately 50%, while the free enzyme was maintained at approximately 20%. However, modification with cyclodextrin did not alter the thermal stability. The transesterification yield was found to be approximately 55% for the free enzyme, while it was found to be approximately 68% and 77% for PER-SC and PER-CD-SC, respectively. The effect of metal ions and salts on transesterification yield was examined. The results showed that the addition of metal ions decreased the percentage of transesterification by approximately 10% compared to the control group, whereas the addition of salt significantly decreased the percentage of transesterification by 60-80% compared to the control group.
在这项研究中,使用无机载体珍珠岩(PER)和环糊精修饰的珍珠岩(PER-CD)来固定枯草杆菌蛋白酶(SC)。为了进行酶固定化,首先用 3-氨丙基三乙氧基硅烷对载体进行氨基化,然后用戊二醛(GA)和京尼平(GE)进行活化,然后得到固定化酶(PER-SC 和 PER-CD-SC)。SC 固定化的反应介质由 500mg 载体和 5ml(1mg/ml)酶溶液组成。固定化条件为 pH8.0、25°C 和 2h 孵育时间。游离和固定化的 SC 用于在四氢呋喃(THF)中用 1-丙醇对 N-乙酰-L-苯丙氨酸乙酯(APEE)进行转酯化反应。通过气相色谱(GC)测定酶的转酯化活性和转酯化反应的产率。将 50mg 固定化或 2.5mg 游离 SC 添加到反应介质中,该反应介质由 1mmolAPEE 和 10mmol 醇在 10mLTHF 中制备。转酯化反应的条件为 60°C 和 24h 孵育。使用扫描电子显微镜(SEM)和热重分析(TGA)对制备的载体的结构和表面形态进行了表征。在优化研究中使用了酪蛋白底物。发现游离和固定化 SC 的最适温度和 pH 值分别为 50°C 和 pH8.0。固定化 SC 的热稳定性大于游离 SC。在高温暴露 4h 后,固定化酶的活性保持在约 50%,而游离酶的活性保持在约 20%。然而,用环糊精修饰并没有改变热稳定性。游离酶的转酯化产率约为 55%,而 PER-SC 和 PER-CD-SC 的转酯化产率分别约为 68%和 77%。考察了金属离子和盐对转酯化产率的影响。结果表明,与对照组相比,金属离子的添加使转酯化率降低了约 10%,而盐的添加使转酯化率降低了约 60-80%。