Fikry Mohammad, Benjakul Soottawat, Al-Ghamdi Saleh, Tagrida Mohamed, Prodpran Thummanoon
Department of Agricultural and Biosystems Engineering, Faculty of Agriculture, Benha University, Moshtohor, Toukh 13736, Egypt.
International Center of Excellence in Seafood Science and Innovation, Faculty of Agro-Industry, Prince of Songkla University, Hat Yai, Songkhla 90110, Thailand.
Foods. 2023 Aug 11;12(16):3024. doi: 10.3390/foods12163024.
Convection drying in combination with ultrasound pretreatment has emerged as a promising technology for seafood manufacturing. The primary objective of this research was to model the mass transfer process of Asian seabass () fish skin without and with ultrasound pretreatment during convection drying at different temperatures (45, 55, and 65 °C). Additionally, the study aimed to examine the impact of ultrasound pretreatment and temperatures on the drying characteristics and specific energy consumption for drying of Asian seabass fish skin. Seven semi-theoretical models, namely Lewis, Page, modified Page, Vega-Lemus, Verma, Henderson and Pabis, and two-term models, were employed to characterize the moisture transfer process. The results of the study indicated a decrease in the moisture content as the drying time increased at different drying temperatures. Higher drying temperatures were associated with an increased drying rate. Among the mathematical models tested, the modified Page model provided a satisfactory description of the thin-layer drying characteristics of fish skin. Fick's law of diffusion was utilized to determine the effective moisture diffusivities. Comparing the drying of fish skin without (SS) and with ultrasound pretreatment (US-SS), the drying of the latter generally showed higher D values. The temperature dependence of the effective diffusivity coefficient was well described by the Arrhenius-type model. An increase in the drying temperature resulted in an increment of the effective moisture diffusivity. In general, the skin pretreated using ultrasound had a reduced drying time, by up to 28%. Additionally, this approach contributed to an approximate 22% reduction in the specific energy consumption, concurrently enhancing the energy efficiency. The microstructure analysis showed that fresh and dried US-SS samples had a more open structure and higher porosity, in comparison to the corresponding SS samples. These findings contribute to the knowledge on the application of ultrasound as the pretreatment of fish skin before drying and provide valuable insights for the development of potential drying techniques in the seafood industry.
对流干燥结合超声预处理已成为海产品制造领域一项很有前景的技术。本研究的主要目的是对亚洲鲈鱼()鱼皮在不同温度(45、55和65°C)下进行对流干燥时,有无超声预处理情况下的传质过程进行建模。此外,该研究旨在考察超声预处理和温度对亚洲鲈鱼鱼皮干燥特性及干燥比能耗的影响。采用了七个半理论模型,即刘易斯模型、佩奇模型、修正佩奇模型、维加 - 莱穆斯模型、韦尔马模型、亨德森和帕比斯模型以及双项模型,来表征水分传递过程。研究结果表明,在不同干燥温度下,随着干燥时间的增加,水分含量降低。较高的干燥温度与干燥速率的提高相关。在所测试的数学模型中,修正佩奇模型对鱼皮的薄层干燥特性给出了令人满意的描述。利用菲克扩散定律确定有效水分扩散率。比较未进行超声预处理(SS)和经过超声预处理(US - SS)的鱼皮干燥情况,后者的干燥过程通常显示出更高的D值。有效扩散系数的温度依赖性通过阿伦尼乌斯型模型得到了很好的描述。干燥温度升高导致有效水分扩散率增加。一般来说,经过超声预处理的鱼皮干燥时间减少,最多可减少28%。此外,这种方法使比能耗降低了约22% , 同时提高了能源效率。微观结构分析表明,与相应的SS样品相比,新鲜和干燥后的US - SS样品具有更开放的结构和更高的孔隙率。这些发现有助于了解超声作为鱼皮干燥前预处理的应用,并为海产品行业潜在干燥技术的发展提供有价值的见解。