Abbas Khalid K, Abed Mayyadah S, Jasim Ali F
Department of Materials Engineering, University of Technology, Baghdad, IRAQ.
Ministry of Electricity General Directorate of Electric Energy Transportation for Euphrates Middle Region, Baghdad, IRAQ.
Turk J Chem. 2021 Dec 27;46(3):704-720. doi: 10.55730/1300-0527.3361. eCollection 2022.
A new nanocomposite superhydrophobic of the RTV (room temperature vulcanized) silicon rubber reinforced with a different percentage of nanosilica was prepared by a two-stage sol-gel route to obtain a superhydrophobic surface coating on high voltage glass insulator, preventing the dust-water droplet from adhering to its surface. The cold spraying technique was utilized to build up a thin nanocomposite superhydrophobic layer on the glass insulator containing different percentages of the nanosilica particles, such as 23 wt %, 33 wt %, and 44 wt % with RTV silicon substrate. The synthesized nanocomposite was analyzed using the contact angle, roughness, adhesion, hardness, and dielectric strength tests. Moreover, the prepared RTV silicon rubber/nanosilica superhydrophobic nanocomposite layer was characterized using the field emission scanning electron microscope (FESEM), X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), and the particle size analysis test. Based on the results, the nanosilica particles were well-incorporated into the RTV silicon rubber, obtaining an excellent homogenous distribution thin layer on its surface, supporting its capability to be a superior superhydrophobic surface. The results reveal that the RTV silicon rubber/33wt % nanosilica was the best as a superhydrophobic behavior with a contact angle reaching higher than 158° ± 3; also, a significant change in the dielectric strength was obtained to be 25.5 kV (using a speed voltage of 5.0 kV/s). Importantly, the flashover test was also conducted, and it was found that there was a significant change in the leak current between the coated and uncoated samples. The leak current of the coated sample with a superhydrophobic nanocomposite was reduced to 2.5 mA, while the uncoated sample became 3.2 mA using a voltage load value of 60 kV. The results presented here may improve the nanocomposite material as an antiweathering superhydrophobic thin layer supported by the prepared nano-SiO particles against the dust-water droplets which may be adhesive to the high voltage glass insulator.
通过两步溶胶 - 凝胶法制备了一种用不同百分比纳米二氧化硅增强的新型室温硫化(RTV)硅橡胶纳米复合超疏水材料,以在高压玻璃绝缘子上获得超疏水表面涂层,防止灰尘 - 水滴附着在其表面。利用冷喷涂技术在含有不同百分比纳米二氧化硅颗粒(如23 wt%、33 wt%和44 wt%)的RTV硅基底的玻璃绝缘子上构建薄的纳米复合超疏水层。使用接触角、粗糙度、附着力、硬度和介电强度测试对合成的纳米复合材料进行分析。此外,用场发射扫描电子显微镜(FESEM)、X射线衍射(XRD)、傅里叶变换红外光谱(FTIR)和粒度分析测试对制备的RTV硅橡胶/纳米二氧化硅超疏水纳米复合层进行表征。基于结果,纳米二氧化硅颗粒很好地掺入RTV硅橡胶中,在其表面获得了优异的均匀分布薄层,证明其有能力成为优异的超疏水表面。结果表明,RTV硅橡胶/33wt%纳米二氧化硅作为超疏水性能最佳,接触角达到高于158°±3;同时,介电强度有显著变化,为25.5 kV(使用5.0 kV/s的升压速度)。重要的是,还进行了闪络测试,发现涂覆和未涂覆样品之间的泄漏电流有显著变化。使用60 kV的电压负载值时,涂覆有超疏水纳米复合材料的样品的泄漏电流降至2.5 mA,而未涂覆样品变为3.2 mA。这里给出的结果可能会改进纳米复合材料,使其作为一种抗风化超疏水薄层,由制备的纳米SiO颗粒支撑,以抵抗可能附着在高压玻璃绝缘子上的灰尘 - 水滴。