Almohareb Thamer, Al Ahdal Khold, Maawadh Ahmed M, Al Deeb Laila, Alshamrani Ahoud S, Alrahlah Ali
Restorative Dental Science Department, College of Dentistry, King Saud University, Riyadh 11545, Saudi Arabia.
Restorative Dental Science Department, College of Dentistry, King Saud University, Riyadh 11545, Saudi Arabia.
Photodiagnosis Photodyn Ther. 2024 Feb;45:103943. doi: 10.1016/j.pdpdt.2023.103943. Epub 2023 Dec 24.
Bleached enamel reversal using antioxidants sodium ascorbate (SA), Green tea extract (GTE), grape seed extract (GSE), Curcumin photosensitizer (CP) and Er: YAG laser on the adhesive strength and marginal leakage of composite material bonded to the bleached enamel surface.
Enamel surface of hundred and twenty sound human first premolar teeth was cleansed using pumice and bleached with 35 % hydrogen peroxide. The samples were randomly divided into 5 groups based on the antioxidants used. n = 20 Group 1 (Control): No antioxidant agent, Group 2: 10 % SA solution, Group 3: 6.5 % GSE, Group 4: 5 % GTE, Group 5: Er: YAG laser and Group 6: CP. Following reversal, the composite was built and cured for 40 s. All the specimens were stored in distilled water at room temperature for 1 day. Microleakage, SBS, and failure mode were analyzed. Kolmogorov-Smirnov test, one-way analysis of variance, and Tukey's multiple post hoc test were used to analyze the data statistically.
Group 2 (SA) (20.11 ± 5.79 nm) exhibited minimum value of microleakage and highest SBS (10.22 ± 1.62 MPa). Whereas, Group 1 (No antioxidant agent) displayed maximum scores of marginal leakage (28.11±8.89 nm) and lowest SBS (7.02 ± 1.22 MPa).
CP, GTE and GSE can be used as a potential alternative to the commonly used SA solution to reverse the negative impact of bleaching on the enamel surface. The use of reversal agents CP, GTE and GSE improves bond values with a decrease in microleakage scores However, future studies are still warranted to conclude the outcomes of the existing study.
使用抗氧化剂抗坏血酸钠(SA)、绿茶提取物(GTE)、葡萄籽提取物(GSE)、姜黄素光敏剂(CP)以及铒钇铝石榴石激光(Er:YAG激光)来逆转牙釉质漂白,并研究其对粘结于漂白牙釉质表面的复合材料的粘结强度和边缘微渗漏的影响。
用浮石清洁120颗健康人第一前磨牙的牙釉质表面,并用35%的过氧化氢进行漂白。根据所使用的抗氧化剂,将样本随机分为5组。n = 20:第1组(对照组):不使用抗氧化剂;第2组:10%的SA溶液;第3组:6.5%的GSE;第4组:5%的GTE;第5组:Er:YAG激光;第6组:CP。逆转处理后,构建复合材料并固化40秒。所有标本在室温下于蒸馏水中保存1天。分析微渗漏、剪切粘结强度(SBS)及失效模式。采用柯尔莫哥洛夫-斯米尔诺夫检验、单因素方差分析和图基多重事后检验对数据进行统计学分析。
第2组(SA)(微渗漏值为20.11±5.79纳米)显示出最小的微渗漏值和最高的SBS(10.22±1.62兆帕)。而第1组(不使用抗氧化剂)的边缘微渗漏得分最高(28.11±8.89纳米),SBS最低(7.02±1.22兆帕)。
CP、GTE和GSE可作为常用SA溶液的潜在替代品,以逆转漂白对牙釉质表面的负面影响。使用逆转剂CP、GTE和GSE可提高粘结值,同时降低微渗漏得分。然而,仍需进一步研究以确定现有研究的结果。