Research and Development, Glopal Napi Pharmaceuticals, 6th October City, Giza 12511, Egypt.
Department of Pharmaceutical Analytical Chemistry, Faculty of Pharmacy, Menoufia University, Shebin El-Koum 32511, Egypt.
J Pharm Biomed Anal. 2024 May 15;242:116021. doi: 10.1016/j.jpba.2024.116021. Epub 2024 Feb 8.
Multicomponent drugs are medications that combine two or more active pharmaceutical ingredients in a single dosage form. These dosage forms improve the patient compliance, reduce the risk of drug interactions, and simplify dosing regimens. However, quality control of these multicomponent dosage forms can be challenging, especially if the final product contains four or more ingredients that are active (comprise stabilizers, preservatives, excipients, and other components). This problem can be more pronounced if the excipients can interfere with the analysis. In this work, a stability indicating assay method was developed and validated (according to the ICH International Guidelines) for the simultaneous determination of hydroquinone (HQ), tretinoin (TRT), hydrocortisone (HCA), butylated hydroxytoluene (BHT), methyl paraben (MP) and propyl paraben (PP) in commercially available pharmaceutical creams. The proposed method is based on gradient elution using X-Bridge C18 (150 × 4.6 mm, 5 µm) column with a flow rate of 1 mL/min. The linear ranges (μg/mL) were 240-560 for HQ, 24-56 for MP, 132-308 for HCA, 6-14 for PP, 12-28 for BHT, 6.6-15 for TRT. During the validation process, the intra- and interday precision and trueness (evaluated as recovery) were found to be below 2.0% and between 100-102%, respectively. System suitability tests (SST) allow validating the herein proposed procedure specifically for pharmaceutical and industrial applications. SST test shows that the reported procedure fulfill with the Guidelines, allowing excellent separation of the analytes with very sensitive, accurate (precise and true) and reproducible quantitation of each analytes. The method was successfully applied in forced degradation studies of the six analytes. Specifically, acid degradation slightly affected HCA and BHT (91% recovery), while alkaline degradation drastically reduced HCA recovery (5.5%) and moderately affected BHT (85%). Photodegradation primarily influenced TRT quantity, and oxidative degradation intensified the BHT peak (130%).
多组分药物是将两种或多种活性药物成分组合在单一剂量形式中的药物。这些剂型提高了患者的依从性,降低了药物相互作用的风险,并简化了给药方案。然而,这些多组分剂型的质量控制可能具有挑战性,特别是如果最终产品包含四种或更多种活性成分(包括稳定剂、防腐剂、赋形剂和其他成分)。如果赋形剂会干扰分析,则会使这个问题更加突出。在这项工作中,开发并验证了一种稳定性指示测定方法(根据 ICH 国际指南),用于同时测定市售乳膏剂中对苯二酚 (HQ)、维 A 酸 (TRT)、氢化可的松 (HCA)、叔丁基对羟基甲苯 (BHT)、对羟基苯甲酸甲酯 (MP) 和对羟基苯甲酸丙酯 (PP) 的含量。所提出的方法基于梯度洗脱,使用 X-Bridge C18(150×4.6mm,5μm)柱,流速为 1mL/min。 HQ 的线性范围(μg/mL)为 240-560,MP 为 24-56,HCA 为 132-308,PP 为 6-14,BHT 为 12-28,TRT 为 6.6-15。在验证过程中,发现日内和日间精密度和准确度(以回收率表示)均低于 2.0%,回收率在 100-102%之间。系统适用性测试(SST)允许专门针对制药和工业应用验证本文提出的程序。SST 测试表明,所报告的程序符合指南要求,能够极好地分离分析物,对每个分析物的定量具有非常灵敏、准确(精确和真实)和可重现的特点。该方法成功应用于六种分析物的强制降解研究。具体而言,酸降解对 HCA 和 BHT 的影响较小(回收率为 91%),而碱降解则极大地降低了 HCA 的回收率(5.5%),并适度影响了 BHT(85%)。光降解主要影响 TRT 的含量,而氧化降解则增强了 BHT 的峰(130%)。