Chellappan Lingeswari, Thangaraj Balu, Muthukurumban Nagarajan, Gurusamy Vasuki
Research Department of Physics, V. O. Chidambaram College, Thoothukudi, 628 008, Tamil Nadu, India.
Affiliated to Manonmaniam Sundaranar University, Abishekapatti, Tirunelveli, 627 012, Tamil Nadu, India.
J Fluoresc. 2025 Mar;35(3):1549-1564. doi: 10.1007/s10895-024-03605-z. Epub 2024 Feb 24.
Pure and Mg, Ni, Cd doped MnO nanoparticles were synthesized by chemical co-precipitation method. These samples were characterised by PXRD, SEM, EDX, FTIR, UV-Vis-NIR, PL, Antibacterial, Cyclic Voltammetry, Dye Degradation and Photocatalytic studies. From the powder XRD studies, the crystallite size of the particle was calculated using Scherer formula and found that the synthesized nanoparticles were in the range from 10 to 12 nm. The morphology of all the synthesized samples was viewed from SEM micrograph. The composition and purity of the samples were identified from EDX studies. In FTIR spectra metal-oxygen stretching and bending modes of vibrations were observed. From the absorption spectra of UV-Vis optical analysis values of absorption coefficient, extinction coefficient, refractive index, real and imaginary part of optical dielectric constant and optical conductivity were compared. The band gap energy obtained from Tauc's plot varies from 1.21 to 1.51 eV exhibits semiconducting behaviour of all the synthesized samples. Investigations on photoluminecsence spectrum reveals blue shift in wavelength for doped nanooxides compared to pure MnO. Antimicrobial activity of synthesised samples against gram positive and gram negative bacteria was determined. The obtained results reveal very high bacterial resistance in Cd doped MnO nanoparticles with higher activity towards bacterial resistance compared to standard drug. The specific capacitance values were determined from Cyclic Voltammetry studies. Using the batch method of dye removing technique the percentage of malachite green dye removal was calculated. Also the photocatalytic efficiency of all the synthesized MnO samples in removing malachite green dye was studied by exposing to sunlight for different dosage and contact time. Ni doped MnO shows relatively higher % of dye degradation capacity about 93% for 0.1 g of dosage of photocatalysts.
采用化学共沉淀法合成了纯的以及镁、镍、镉掺杂的二氧化锰纳米颗粒。通过粉末X射线衍射(PXRD)、扫描电子显微镜(SEM)、能谱分析(EDX)、傅里叶变换红外光谱(FTIR)、紫外-可见-近红外光谱(UV-Vis-NIR)、光致发光(PL)、抗菌性能、循环伏安法、染料降解和光催化研究对这些样品进行了表征。通过粉末XRD研究,使用谢乐公式计算了颗粒的微晶尺寸,发现合成的纳米颗粒尺寸在10至12纳米范围内。从SEM显微照片观察了所有合成样品的形貌。通过EDX研究确定了样品的组成和纯度。在FTIR光谱中观察到了金属-氧的伸缩振动和弯曲振动模式。从紫外-可见光谱的吸收光谱中,比较了吸收系数、消光系数、折射率、光学介电常数的实部和虚部以及光导率的光学分析值。从陶氏图获得的带隙能量在1.21至1.51电子伏特之间变化,表明所有合成样品均表现出半导体行为。对光致发光光谱的研究表明,与纯MnO相比,掺杂纳米氧化物的波长发生蓝移。测定了合成样品对革兰氏阳性菌和革兰氏阴性菌的抗菌活性。所得结果表明,镉掺杂的MnO纳米颗粒具有很高的抗菌性,与标准药物相比,其抗菌活性更高。通过循环伏安法研究确定了比电容值。使用分批法染料去除技术计算了孔雀石绿染料的去除率。此外,通过在不同剂量和接触时间下暴露于阳光下,研究了所有合成的MnO样品去除孔雀石绿染料的光催化效率。对于0.1克光催化剂剂量,镍掺杂的MnO显示出相对较高的染料降解能力,约为93%。