Largo-Avila Esteban, Rico-Rodríguez Fabián, Peñaloza-Figueroa Jeanine Kathleen, López-Padilla Alexis
Caicedonia Regional Campus, Universidad del Valle, Cali, Colombia.
Food Engineering Department, Universidad de Cartagena, Cartagena de Indias, Colombia.
Front Nutr. 2024 Apr 23;11:1307423. doi: 10.3389/fnut.2024.1307423. eCollection 2024.
Currently, approximately 34% of fruit is lost and wasted in emerging economies due to inefficient post-harvest processes, technological shortcomings, lesser valorization of surpluses, and byproducts. Peach ( L.) is a fruit with a good yearly growth rate but higher postharvest losses in Colombia. One way to take advantage of this type of product is through the application of drying processes that increase its shelf life and its inclusion in the food chain. Refractance Window Drying (RWD) is a fourth generation drying technique implemented by the food industry in the last few decades and has been applied to several dehydrated food products. This study compared the effects of different drying methods on the physical and sensory properties of peaches surplus. Treatments consisted of (i) peaches were sliced (1, 2, and 3 mm thickness) and dried using RWD at 86°C, (ii) peach pulp mixed with maltodextrin (MD) (0.12-0.33 kg of MD/kg of sample) and RWD (RWD-MD), and (iii) conventional oven drying (OD) at 60°C (3 mm thick) dried for 24 h. The study found that the drying method significantly ( < 0.05) affected the texture, color, and general taste of peaches. The results showed that processing treatments combined with different drying conditions affected the physical properties of the peach. RWD in slices reduced water content to 0.05 kg HO/kg in 40 min, showing fewer effects on color attributes. A surface response analysis on RWD showed good correlations for water activity ( = 0.8652-0.9894) and moisture content ( = 0.7048-0.9826). A higher diffusion coefficient (1.63 × 10 m s) was observed for RWD in slices with 3 × 10 m of thickness; however, for RWD-MD, differences in diffusion coefficients were present for the lowest MD addition (0.12 kg/kg), vitamin C was not detected on the dried slices, and higher concentration of β-carotene (175.88 μg/100 g) was found on the thinner slices. Principal component analysis showed that RWD in the slices was the most suitable drying process, followed by OD. Sensory analysis showed good acceptability for RWD slices after 30 days of storage.
目前,由于收获后处理效率低下、技术缺陷、剩余产品和副产品的价值利用不足,新兴经济体中约34%的水果损失和浪费。桃(L.)是一种年产量增长率良好但在哥伦比亚收获后损失较高的水果。利用这类产品的一种方法是通过应用干燥工艺,延长其保质期并将其纳入食物链。折射窗干燥(RWD)是食品工业在过去几十年中采用的第四代干燥技术,已应用于多种脱水食品。本研究比较了不同干燥方法对桃剩余物物理和感官特性的影响。处理包括:(i)将桃切片(1、2和3毫米厚),并在86°C下使用RWD干燥;(ii)将桃果肉与麦芽糊精(MD)(0.12 - 0.33千克MD/千克样品)混合并进行RWD(RWD - MD);(iii)在60°C下进行常规烘箱干燥(OD)(3毫米厚),干燥24小时。研究发现,干燥方法对桃的质地、颜色和总体口感有显著影响(<0.05)。结果表明,结合不同干燥条件的加工处理会影响桃的物理特性。切片的RWD在40分钟内将水分含量降至0.05千克水/千克,对颜色属性的影响较小。对RWD的表面响应分析表明,水分活度(=0.8652 - 0.9894)和水分含量(=0.7048 - 0.9826)具有良好的相关性。对于厚度为3×10米的切片RWD,观察到较高的扩散系数(1.63×10米²/秒);然而,对于RWD - MD,在最低MD添加量(0.12千克/千克)时扩散系数存在差异,干燥切片中未检测到维生素C,较薄切片中发现较高浓度的β - 胡萝卜素(175.88微克/100克)。主成分分析表明,切片的RWD是最合适的干燥工艺,其次是OD。感官分析表明,储存30天后RWD切片具有良好的可接受性。