Influence of the Plastic Deformation Process on the Residual Stresses and Hardness of an Al-5Mg Alloy.

The service behavior of ductile metallic materials, when they have previously undergone technological plastic deformation, depends on the deformation conditions. These are represented, among others, by the deformation rate, the process temperature, the applied pressures, and the introduced stresses, as well as other process variables. The investigation of the mechanical properties obtained after plastic deformation is an important means that contains two characteristics: on the one hand, to determine to what extent the parameters of the technological manufacturing process influence the main characteristics of the final component; and, on the other hand, on the basis of these characteristics, to analyze whether the component subjected to plastic deformation will be able to function reliably and safely. In the present work, an experimental study was made of the residual stresses developed and hardnesses obtained both in the immediate vicinity of a highly plastically deformed area and in an area previously obtained by rolling, without additional plastic deformation. For the determination of the residual stresses, the tensiometric rosette drilling method was used. By determining the same quantities in a non-plastically deformed area, significant changes in the values of the two quantities in the plastically deformed area were found. An increase in the maximum principal normal stresses by approx. 60 MPa and an increase in the Rockwel hardness by approx. 10 HRC was found. A sample was taken from the area under a plastic deformed circular shape, and was analyzed microscopically.