School of Biochemical Engineering and Technology, Sirindhorn International Institute of Technology, Thammasat University, P.O. Box 22, Pathum Thani, 12121, Thailand.
Environ Sci Pollut Res Int. 2024 Aug;31(38):50767-50781. doi: 10.1007/s11356-024-34554-6. Epub 2024 Aug 5.
This study comprehensively investigated the abundance, morphologies, and polymer types of plastics, larger (1-5 mm) and smaller (< 1 mm) microplastics (MPs), in organic fertilizers using spectroscopic and microscopic methods. MPs abundance varied depending on the type of waste employed. MPs were detected in 80% of the investigated compost samples, while macro/meso plastics were found in only four samples. Compost from mixed municipal solid waste exhibited the highest MPs contamination (23100 ± 3615 items/kg dry weight), whereas compost produced from canteen waste had the lowest contamination (100 ± 65 items/kg dry weight). Smaller MPs were dominant in all samples. The estimated loads of MPs introduced into agricultural soil exceeded the previous studies. Common morphologies observed were sheet, film, fragment, and fiber, while dominant polymer types were polyethylene (PE), polypropylene (PP), polyvinyl chloride (PVC), polyethylene terephthalate (PET), and polystyrene (PS). Heavy metals, including Cr, Cu, Ni, and Pb, were identified in association with MPs. Results indicate that the utilization of appropriate waste for composting and upgrading fertilizer regulations is crucial to protect the environment and human health from smaller MPs.
本研究采用光谱和显微镜方法,全面调查了有机肥中塑料、较大(1-5 毫米)和较小(<1 毫米)微塑料(MPs)的丰度、形态和聚合物类型。MPs 的丰度取决于所使用的废物类型。在 80%的调查堆肥样本中检测到 MPs,而在仅四个样本中发现了大/中塑料。来自混合城市固体废物的堆肥表现出最高的 MPs 污染(23100±3615 个/千克干重),而来自食堂废物的堆肥污染最低(100±65 个/千克干重)。所有样本中均以较小的 MPs 为主。估计引入农业土壤的 MPs 负荷超过了先前的研究。观察到的常见形态有片、膜、碎片和纤维,而主要的聚合物类型为聚乙烯(PE)、聚丙烯(PP)、聚氯乙烯(PVC)、聚对苯二甲酸乙二醇酯(PET)和聚苯乙烯(PS)。 MPs 中还鉴定出了 Cr、Cu、Ni 和 Pb 等重金属。结果表明,为了保护环境和人类健康免受较小 MPs 的影响,合理利用适当的废物进行堆肥和升级肥料法规至关重要。