Ketchum L D
Hand Clin. 1985 Feb;1(1):43-53.
Immediately after a tendon repair, the tendon contributes nothing to the strength of repair. During that time, the suture itself and suture technique are the sole contributors to the strength of repair. Although stainless steel is the strongest material that can be used at the time of repair, it has serious disadvantages. It is difficult to work with and makes a bulky knot. Conversely, all absorbable sutures become too weak too soon to be of value. At this time, nonabsorbable, synthetic fibers that are relatively strong, such as Supramid or prolene, are the most desirable materials available. Regarding suture techniques, the lateral trap and end-weave techniques produce the strongest repairs; however, the end-weave technique can only be used with tendon grafts and the lateral trap, though it can be used for end-to-end primary repairs. It is too bulky for use in the fingers and hand but is ideal for the forearm and wrist. In the hand and fingers, the strongest repair techniques available are the Bunnell, Kessler, and Mason-Allen; however, the Bunnell stitch is more strangulating to the microcirculation of the tendon than the latter two stitches; thus, it contributes to tendomalacia and gap formation. The simplest and least traumatic suture technique, though weakest at first, will allow tendon healing to proceed more rapidly. If such a repair is protected from tension by splinting the wrist and metacarpophalangeal joints in flexion during healing (while allowing controlled passive motion of the finger joints), there will be a rapid increase in tensile strength of the tendon juncture with minimal gap formation, as the repaired hand is progressively stressed up until about 90 days postrepair. At that point, strength plateaus and maximum stress can be applied to the repaired tendon. Somewhere between three and six weeks post-tendon repair, the suture material and technique become secondary to tendon healing as the primary provider of tensile strength to the tendon wound. The less traumatic suture techniques facilitate closure of the tendon sheath, which not only acts as a mechanical barrier to the ingrowth of extrasheath adhesion, which produces fibroblasts, but also re-establishes the continuity of the synovial fluid system, which is a major source of nutrition to the tendon. The healing tendon then can be thought of as a delicate structure, one not to be overmanipulated, traumatized, strangulated, or stretched.(ABSTRACT TRUNCATED AT 400 WORDS)
肌腱修复后即刻,肌腱对修复强度没有贡献。在此期间,缝线本身和缝合技术是修复强度的唯一决定因素。虽然不锈钢是修复时可用的最强材料,但它有严重缺点。它操作困难,打结后体积较大。相反,所有可吸收缝线过早变弱而失去价值。此时,相对较强的不可吸收合成纤维,如Supramid或普理灵,是最理想的可用材料。关于缝合技术,侧方圈套缝合法和端-编织缝合法产生的修复强度最强;然而,端-编织缝合法仅适用于肌腱移植,而侧方圈套缝合法虽然可用于端端一期修复,但用于手指和手部时体积太大,不过用于前臂和腕部则很理想。在手部和手指,可用的最强修复技术是邦内尔缝合法、凯斯勒缝合法和梅森-艾伦缝合法;然而,邦内尔缝合法对肌腱微循环的绞勒作用比后两种缝合法更强;因此,它会导致肌腱软化和间隙形成。最简单且创伤最小的缝合技术,虽然一开始最弱,但能使肌腱愈合更快进行。如果在愈合过程中通过将腕关节和掌指关节固定在屈曲位来防止这种修复受到张力(同时允许手指关节进行可控的被动活动),随着修复后的手逐渐承受压力直至修复后约90天,肌腱结合处的抗张强度将迅速增加,间隙形成最小。此时,强度趋于平稳,可对修复后的肌腱施加最大应力。在肌腱修复后三到六周的某个时间点,缝线材料和技术对于肌腱伤口抗张强度的主要提供者——肌腱愈合来说变得次要。创伤较小的缝合技术有助于腱鞘闭合,腱鞘不仅作为防止鞘外粘连向内生长(产生成纤维细胞)的机械屏障,还能重新建立滑膜液系统的连续性,而滑膜液系统是肌腱营养的主要来源。然后,愈合中的肌腱可被视为一个 delicate结构,不应过度操作、创伤、绞勒或拉伸。(摘要截选至400字)