Goudarzi Sobhan, Jones Ryan Matthew, Lee Yin Hau Wallace, Hynynen Kullervo
Physical Sciences Platform, Sunnybrook Research Institute, Toronto, Ontario, Canada.
Department of Medical Biophysics, University of Toronto, Toronto, Ontario, Canada.
Med Phys. 2024 Dec;51(12):8670-8687. doi: 10.1002/mp.17427. Epub 2024 Sep 28.
During magnetic resonance-guided focused ultrasound (MRgFUS) surgery for uterine fibroids, ablation of fibrous tissues in proximity to the hips and spine is challenging due to heating within the bone that can cause patients to experience pain and potentially damage nerves. This far-field bone heating limits the volume of fibroid tissue that is treatable via MRgFUS.
To investigate transducer module apodization for improving the ratio of focal-to-bone heating ( ) when targeting fibroid tissue close to the hips and spine, to enable MRgFUS treatments closer to the bone.
Acoustic and thermal simulations were performed using 3D magnetic resonance imaging (MRI)-derived anatomies of ten patients who underwent MRgFUS ablation for uterine fibroids using a low-frequency ( ) 6144-element flat fully-populated modular phased array system (Arrayus Technologies Inc., Burlington, Canada) at our institution as part of a larger clinical trial (NCT03323905). Transducer modules ( per module) whose beams intersected with no-pass zones delineated within the field were identified, their output power levels were reduced by varying blocking percentage levels, and the resulting temperature field distributions were evaluated across multiple sonications near the hip and spine bones in each patient. Acoustic and thermal simulations took approximately ( ) and ( ) to run for a single near-spine (near-hip) target, respectively.
For all simulated sonications, transducer module blocking improved compared to the no blocking case. In just over half of sonications, full module blocking maximized (increase of 82% 38% in 50% of hip targets and 49% 30% in 62% of spine targets vs. no blocking; mean ± SD), at the cost of more diffuse focusing (focal heating volumes increased by 13% ± 13% for hip targets and 39% ± 27% for spine targets) and thus requiring elevated total (hip: 6% ± 17%, spine: 37% ± 17%) and peak module-wise (hip: 65% ± 36%, spine: 101% ± 56%) acoustic power levels to achieve equivalent focal heating as the no blocking control case. In the remaining sonications, partial module blocking provided further improvements in both (increased by 29% ± 25% in the hip and 15% ± 12% in the spine) and focal heating volume (decrease of 20% ± 10% in the hip and 34% ± 17% in the spine) relative to the full blocking case. The optimal blocking percentage value was dependent on the specific patient geometry and target location of interest. Although not all individual target locations saw the benefit, element-wise phase aberration corrections improved the average compared to the no correction case (increase of 52% ± 47% in the hip, 35% ± 24% in the spine) and impacted the optimal blocking percentage value. Transducer module blocking enabled ablative treatments to be carried out closer to both hip and spine without overheating or damaging the bone (no blocking: / , full blocking: / , optimal partial blocking: / for hip/spine).
The proposed transducer apodization scheme shows promise for improving MRgFUS treatments of uterine fibroids, and may ultimately increase the effective treatment envelope of MRgFUS surgery in the body by enabling tissue ablation closer to bony structures.
在磁共振引导聚焦超声(MRgFUS)治疗子宫肌瘤的手术中,由于骨骼内部发热会导致患者疼痛并可能损伤神经,因此对靠近髋部和脊柱的纤维组织进行消融具有挑战性。这种远场骨加热限制了可通过MRgFUS治疗的肌瘤组织体积。
研究换能器模块变迹技术,以提高在靶向靠近髋部和脊柱的肌瘤组织时的焦点与骨加热比( ),从而使MRgFUS治疗能够更接近骨骼。
使用3D磁共振成像(MRI)得出的十名接受MRgFUS消融子宫肌瘤患者的解剖结构进行声学和热模拟,这些患者在我们机构使用低频( )6144元件平面全填充模块化相控阵系统(Arrayus Technologies Inc.,加拿大伯灵顿)进行治疗,这是一项更大临床试验(NCT03323905)的一部分。识别出其波束与场内划定的禁通区相交的换能器模块(每个模块 ),通过改变阻挡百分比水平来降低其输出功率水平,并在每个患者的髋部和脊柱骨附近的多次超声处理中评估所得的温度场分布。对于单个靠近脊柱(靠近髋部)的目标,声学和热模拟分别大约需要 ( )和 ( )来运行。
对于所有模拟的超声处理,与无阻挡情况相比,换能器模块阻挡提高了 。在略超过一半的超声处理中,完全模块阻挡使 最大化(与无阻挡相比,50%的髋部目标增加了82% ± 38%,62%的脊柱目标增加了49% ± 30%;平均值 ± 标准差),代价是聚焦更分散(髋部目标的焦点加热体积增加了13% ± 13%,脊柱目标增加了39% ± 27%),因此需要提高总(髋部:6% ± 17%,脊柱:37% ± 17%)和模块峰值(髋部:65% ± 36%,脊柱:101% ± 56%)声功率水平,以实现与无阻挡对照情况相当的焦点加热。在其余的超声处理中,部分模块阻挡相对于完全阻挡情况在 (髋部增加了29% ± 25%,脊柱增加了15% ± 12%)和焦点加热体积(髋部减少了20% ± 10%,脊柱减少了34% ± 17%)方面都有进一步改善。最佳阻挡百分比值取决于特定患者的几何形状和感兴趣的目标位置。尽管并非所有单个目标位置都能受益,但与无校正情况相比,逐元素相位像差校正提高了平均 (髋部增加了52% ± 47%,脊柱增加了35% ± 24%),并影响了最佳阻挡百分比值。换能器模块阻挡能够在更靠近髋部和脊柱的位置进行消融治疗,而不会使骨骼过热或受损(无阻挡: / ,完全阻挡: / ,髋部/脊柱的最佳部分阻挡: / )。
所提出的换能器变迹方案显示出改善MRgFUS治疗子宫肌瘤的前景,并最终可能通过使组织消融更靠近骨结构来扩大MRgFUS手术在体内的有效治疗范围。