Suppr超能文献

尺骨骨折水平对桡骨头脱位的影响:孟氏骨折研究

Impact of ulnar fracture level on radial head dislocation: A Monteggia fracture study.

作者信息

Huang Kuan-Yu, Chen Chun-Yu, Lin Kai-Cheng

机构信息

Department of Orthopaedics, Kaohsiung Veterans General Hospital, Kaohsiung, Taiwan, ROC.

Department of Occupational Therapy, Shu-Zen Junior College of Medicine and Management, Kaohsiung, Taiwan, ROC.

出版信息

J Chin Med Assoc. 2025 Sep 1;88(9):686-691. doi: 10.1097/JCMA.0000000000001276. Epub 2025 Jul 30.

Abstract

BACKGROUND

Monteggia fracture is defined as a combination of a proximal ulnar fracture with radial head dislocation. Radial head dislocation may be misdiagnosed under an elbow radiograph, leading to further complications. This study aimed to compare the ulnar fracture pattern characteristics between Monteggia fracture and an isolated proximal ulnar fracture in terms of how close the fracture site is to the coronoid and what type of fracture pattern is more likely to result in radial head dislocation.

METHODS

This single-center retrospective study, conducted from January 2014 to June 2022, included adult patients with proximal to midshaft ulnar fractures, excluding nonacute trauma, revision surgeries, and intra-articular fractures. All patients underwent anteroposterior (AP) and lateral elbow radiographs and forearm radiograph. Fracture patterns and injury mechanisms were recorded for analysis.

RESULTS

We included 51 patients in this study. The mean age was 38.5 ± 16.1 years, and 70.1% were men (n = 36). Monteggia fractures were classified according to the Bado classification into type I (n = 5), type II (n = 7), type III (n = 8), and type IV (n = 0). Traffic accidents comprised 63% of the injuries (n = 32), and 45% were oblique type ulnar fractures (n = 23). Monteggia fracture and proximal ulnar fracture presented with mean distance from coronoid tip to fracture of 6.12 ± 2.32 cm and 9.00 ± 3.00 cm ( p < 0.01). As per the receiver operating characteristic curve (ROC), the distance from coronoid tip to fracture of 7.33 cm had the highest area under the curve (AUC) value (0.807). Angulations of Monteggia fracture and isolated ulnar fracture were 24.02° ± 12.10° and 10.77° ± 8.10° ( p < 0.01). However, there were no differences in the length of the fracture line between two groups.

CONCLUSION

The distance from coronoid tip to fracture within 7.3 cm is more likely to cause a Monteggia fracture than an isolated proximal ulnar fracture. Otherwise, a Monteggia fracture is prone to more severe angulation.

摘要

背景

孟氏骨折定义为尺骨近端骨折合并桡骨头脱位。桡骨头脱位在肘部X线片下可能被误诊,从而导致进一步的并发症。本研究旨在比较孟氏骨折和单纯尺骨近端骨折之间尺骨骨折类型特征,包括骨折部位与冠突的距离以及哪种骨折类型更易导致桡骨头脱位。

方法

本单中心回顾性研究于2014年1月至2022年6月进行,纳入尺骨近端至中段骨折的成年患者,排除非急性创伤、翻修手术和关节内骨折。所有患者均接受肘部正侧位X线片和前臂X线片检查。记录骨折类型和损伤机制以进行分析。

结果

本研究纳入51例患者。平均年龄为38.5±16.1岁,男性占70.1%(n = 36)。孟氏骨折根据巴多分类法分为I型(n = 5)、II型(n = 7)、III型(n = 8)和IV型(n = 0)。交通事故所致损伤占63%(n = 32),45%为斜形尺骨骨折(n = 23)。孟氏骨折和尺骨近端骨折的冠突尖至骨折处的平均距离分别为6.12±2.32 cm和9.00±3.00 cm(p < 0.01)。根据受试者工作特征曲线(ROC),冠突尖至骨折处距离为7.33 cm时曲线下面积(AUC)值最高(0.807)。孟氏骨折和单纯尺骨骨折的成角分别为24.02°±12.10°和10.77°±8.10°(p < 0.01)。然而,两组之间骨折线长度无差异。

结论

冠突尖至骨折处距离在7.3 cm以内时,相较于单纯尺骨近端骨折,更易导致孟氏骨折。否则,孟氏骨折更容易出现严重成角。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验