Blum J J, Hayes A
J Cell Biochem. 1984;25(4):197-212. doi: 10.1002/jcb.240250403.
The basal ATPase activity of 30S dynein, whether obtained by extraction of ciliary axonemes with a high (0.5 M NaCl) or low (1 mM Tris-0.1 mM EDTA) ionic strength buffer is increased by NaCl, NaNO3, and Na acetate, with NaNO3 causing the largest increase. The calmodulin-activated ATPase activity of 30S dynein is also increased by addition of NaCl, NaNO3, or Na acetate, but the effects are less pronounced than on basal activity, so that the calmodulin activation ratio (CAR) decreases to 1.0 as salt concentration increases to 0.2 M. These salts also reduce the CAR of 14S dynein ATPase to 1.0 but by strongly inhibiting the calmodulin-activated ATPase activity and only slightly inhibiting the basal activity. Sodium fluoride differs both quantitatively and qualitatively from the other three salts studied. It inhibits the ATPase activity of both 14S and 30S dyneins at concentrations below 5 mM and, by a stronger inhibition of the calmodulin-activated ATPase activities, reduces the CAR to 1.0. Na acetate does not inhibit axonemal ATPase, nor does it interfere with the drop in turbidity caused by ATP and extracts very little protein from the axonemes. NaCl and, especially, NaNO3, cause a slow decrease in A350 of an axonemal suspension and an inhibition of the turbidity response to ATP. NaF, at concentrations comparable to those that inhibit the ATPase activities of the solubilized dyneins, also inhibits axonemal ATPase activity and the turbidity response. Pretreatment of demembranated axonemes with a buffer containing 0.25 M sodium acetate for 5 min followed by extraction for 5 min with a buffer containing 0.5 M NaCl and resolution of the extracted dynein on a sucrose density gradient generally yields a 30S dynein that is activated by calmodulin in a heterogeneous manner, ie, the "light" 30S dynein ATPase fractions are more activated than the "heavy" 30S dynein fractions. These results demonstrate specific anion effects on the basal and calmodulin-activated dynein ATPase activities, on the extractability of proteins from the axoneme, and on the turbidity response of demembranated axonemes to ATP. They also provide a method that frequently yields 30S dynein fractions with ATPase activities that are activated over twofold by added calmodulin.
30S动力蛋白的基础ATP酶活性,无论用高离子强度缓冲液(0.5M NaCl)还是低离子强度缓冲液(1mM Tris - 0.1mM EDTA)从纤毛轴丝中提取,都会因NaCl、NaNO3和醋酸钠而增加,其中NaNO3引起的增加最大。添加NaCl、NaNO3或醋酸钠也会增加30S动力蛋白的钙调蛋白激活的ATP酶活性,但这些影响不如对基础活性的影响明显,因此随着盐浓度增加到0.2M,钙调蛋白激活率(CAR)降至1.0。这些盐还会将14S动力蛋白ATP酶的CAR降至1.0,但通过强烈抑制钙调蛋白激活的ATP酶活性,而仅轻微抑制基础活性。氟化钠在数量和质量上与所研究的其他三种盐不同。它在浓度低于5mM时抑制14S和30S动力蛋白的ATP酶活性,并且通过更强地抑制钙调蛋白激活的ATP酶活性,将CAR降至1.0。醋酸钠不抑制轴丝ATP酶,也不干扰ATP引起的浊度下降,并且从轴丝中提取的蛋白质很少。NaCl,尤其是NaNO3,会导致轴丝悬浮液的A350缓慢下降,并抑制对ATP的浊度反应。在与抑制溶解的动力蛋白的ATP酶活性相当的浓度下,NaF也会抑制轴丝ATP酶活性和浊度反应。用含有0.25M醋酸钠的缓冲液对去膜轴丝进行5分钟预处理,然后用含有0.5M NaCl的缓冲液提取5分钟,并在蔗糖密度梯度上分离提取的动力蛋白,通常会得到一种30S动力蛋白,其被钙调蛋白以异质性方式激活,即“轻”30S动力蛋白ATP酶组分比“重”30S动力蛋白组分更易被激活。这些结果证明了特定阴离子对基础和钙调蛋白激活的动力蛋白ATP酶活性、从轴丝中提取蛋白质的能力以及去膜轴丝对ATP的浊度反应的影响。它们还提供了一种方法,该方法经常产生具有被添加的钙调蛋白激活两倍以上的ATP酶活性的30S动力蛋白组分。