Torres H N, Flawiá M M, Medrano J A, Cuatrecasas P
J Membr Biol. 1978 Sep 29;43(1):45-69. doi: 10.1007/BF01869041.
The kinetics of fat cell adenylyl cyclase were studied, with AMP-P(NH)P and Mn++ or Mg++ as the divalent cation. In general, the reaction times were not linear. In the presence of fluoride or GMP-P(NH)P, the time curves were concave upwards; in other cases (i.e., basal activity, insulin, or isoproterenol), transient rates tended to decrease with time during the assay. Kinetic data were analyzed according to a previously described procedures (Torres et al., 1978b) which isolates two kinetic components: initial and final. With AMP-P(NH)P, kinetic activities were about ten times lower than those for ATP. With Mn++, activities were at least two-times higher than for Mg++. Spontaneous inactivation of adenylyl cyclase was higher in assays containing Mg++ than in those supplemented with Mn++. In the latter case, insulin was able to increase the inactivation rate. Fluoride and isoproterenol both activated adenylyl cyclase in both the initial and final kinetic components; under most of the conditions explored, their effects on the final component appeared to be more dramatic. Assays with GMP-P(NH)P showed inhibited activity in the initial component and increased activity in the final one. When the results obtained with AMP-P(NH)P are compared with those of ATP (Torres et al., 1978b. J. Membrane Biol. 43:000), the following differences were found: (i) in the presence of insulin and Mn++, cyclase inactivation was higher with AMP-P(NH)P than with ATP; (ii) fluoride stimulation of the final component was more marked with ATP than with AMP-P(NH)P; (iii) cyclase stimulation by isoproterenol was slightly higher with the nucleotide analog; and (iv) GMP-P(NH)P stimulation of the final component resulted in higher activity with ATP than with AMP-P(NH)P.
以AMP-P(NH)P以及Mn++或Mg++作为二价阳离子,研究了脂肪细胞腺苷酸环化酶的动力学。总体而言,反应时间并非呈线性。在存在氟化物或GMP-P(NH)P的情况下,时间曲线向上凹;在其他情况下(即基础活性、胰岛素或异丙肾上腺素),在测定过程中瞬时速率往往会随时间降低。根据先前描述的程序(Torres等人,1978b)分析动力学数据,该程序分离出两个动力学成分:初始成分和最终成分。使用AMP-P(NH)P时,动力学活性比ATP的低约十倍。使用Mn++时,活性比Mg++时至少高两倍。在含有Mg++的测定中,腺苷酸环化酶的自发失活比在补充有Mn++的测定中更高。在后一种情况下,胰岛素能够提高失活速率。氟化物和异丙肾上腺素在初始和最终动力学成分中均激活腺苷酸环化酶;在探索的大多数条件下,它们对最终成分的影响似乎更为显著。使用GMP-P(NH)P的测定显示初始成分中的活性受到抑制,而最终成分中的活性增加。当将用AMP-P(NH)P获得的结果与ATP的结果(Torres等人,1978b。《膜生物学杂志》43:000)进行比较时,发现了以下差异:(i) 在存在胰岛素和Mn++的情况下,AMP-P(NH)P导致的环化酶失活比ATP更高;(ii) ATP对最终成分的氟化物刺激比AMP-P(NH)P更明显;(iii) 核苷酸类似物对异丙肾上腺素刺激环化酶的作用略高;(iv) GMP-P(NH)P对最终成分的刺激导致ATP的活性比AMP-P(NH)P更高。