Morgan C D, Kalman V R, Grawl D M
Delaware Orthopaedic Center, Wilmington 19810, USA.
Arthroscopy. 1995 Jun;11(3):275-88. doi: 10.1016/0749-8063(95)90003-9.
The purpose of this prospective study was to define constant anatomic intraarticular and extraarticular landmarks that can be used as definitive reference points to reproducibly create a tibial tunnel for anterior cruciate ligament (ACL) reconstruction that (1) results in an impingement-free graft in full extension without an intercondylar roofplasty; (2) positions the tibial tunnel's intraarticular orafice sagittally central in the original ACL insertion without visually guessing; (3) positions the tibial tunnel such that the sagittal tunnel-plateau angle is parallel with the sagittal intercondylar roof-plateau angle in full extension to minimize shear seen by the graft at the tibial tunnel inlet, and by doing so; (4) maximizes tunnel length to avoid patellar tendon graft-tunnel length mismatch allowing for endosteal interference screw fixation on both sides of the joint. Anatomic dissections in 50 knees showed the ACL sagittal central insertion point on the intercondylar floor averages 7 mm (range 7 to 8 mm) sagittally anterior to the anterior margin of the posterior cruciate ligament (PCL) with the knee flexed 90 degrees such that the PCL may be used as a reliable reference landmark for locating the ACL sagittal central insertion. This constant relationship was found to be independent of knee size. Extraarticularly, beginning the tibial tunnel sagittally 1 cm above the superior (sartorial) border of the pes anserinus insertion and coronally 1.5 cm posteromedial from the medial margin of the tibial tubercle along the superior surface of the pes, directed toward the sagittal central ACL insertion, led to a sagittal tunnel-plateau angle that averaged 68 degrees (range 64 degrees to 72 degrees) with a corresponding tunnel length that averaged 58 mm (range 50 to 65 mm) in 23 knees. This data correlated well with data obtained clinically in a series of 50 consecutive ACL reconstructions using intraarticular PCL and extraarticular pes anserine-medial tibial tubercle referenced tibial tunnels in which postoperative full extension lateral radiographs confirmed a sagittal tunnel-plateau angle parallel or near parallel with the intercondylar roof-plateau angle in all cases averaging 68 degrees +/- 3.8 degrees. Tibial tunnel length averaged 60 mm (range 52 to 66 mm) and in no case was there a patellar tendon autograft-tunnel length mismatch.
这项前瞻性研究的目的是确定恒定的关节内和关节外解剖标志,这些标志可作为明确的参考点,以可重复的方式为前交叉韧带(ACL)重建创建胫骨隧道,该隧道要满足以下几点:(1)在不进行髁间顶成形术的情况下,使移植物在完全伸直时无撞击;(2)将胫骨隧道的关节内开口在矢状面上置于原始ACL插入点的中心位置,无需视觉猜测;(3)定位胫骨隧道,使矢状面隧道-平台角在完全伸直时与矢状面髁间顶-平台角平行,以最小化移植物在胫骨隧道入口处受到的剪切力,这样做;(4)最大化隧道长度,以避免髌腱移植物与隧道长度不匹配,从而允许在关节两侧进行骨内干涉螺钉固定。对50个膝关节进行的解剖显示,在膝关节屈曲90度时,ACL在髁间窝底部的矢状面中心插入点平均位于后交叉韧带(PCL)前缘前方7毫米(范围为7至8毫米)处,因此PCL可作为定位ACL矢状面中心插入点的可靠参考标志。发现这种恒定关系与膝关节大小无关。在关节外,从鹅足腱插入点的上(缝匠肌)缘上方1厘米处开始,沿鹅足腱上表面从胫骨结节内侧缘向后内侧1.5厘米处开始,向ACL矢状面中心插入点方向创建胫骨隧道,在23个膝关节中,矢状面隧道-平台角平均为68度(范围为64度至72度),相应的隧道长度平均为58毫米(范围为50至65毫米)。该数据与在一系列50例连续ACL重建中临床获得的数据相关性良好,这些重建使用关节内PCL和关节外鹅足-胫骨结节内侧参考胫骨隧道,术后完全伸直位的外侧X线片证实,所有病例中矢状面隧道-平台角均与髁间顶-平台角平行或接近平行,平均为68度±3.8度。胫骨隧道长度平均为60毫米(范围为52至66毫米),且无一例出现髌腱自体移植物与隧道长度不匹配的情况。