Bostrom M P, Lyden J P, Ernberg J J, Missri A A, Berberian W S
Hospital for Special Surgery, New York, New York, USA.
J Orthop Trauma. 1995 Feb;9(1):45-52. doi: 10.1097/00005131-199502000-00007.
Despite the advantages associated with short-stem intramedullary hip screw devices for the treatment of intertrochanteric fractures, recent reports have shown an increased incidence of femoral shaft fractures after their insertion. These findings led to the hypothesis that an intramedullary hip screw with a longer stem may more effectively redistribute loads to the distal end of the femoral shaft, where they may be more readily absorbed by the increased bony cross-sectional area. To characterize the load patterns of a long-stem device in the femur, 10 fresh-frozen adult femurs were instrumented with unidirectional strain gauges. A total of eight strain gauges were placed in the direction of principal femoral strains on the medial and lateral surfaces of each femur. Each femur was held in a steel vice at 15 degrees of adduction in the coronal plane and vertical in the sagittal plane. The femurs were then subjected to successively increasing vertically applied compressive loads from 0 N to 1,400 N at 200-N increments using a servohydraulic testing machine. Strain values were recorded at each load after a 5-min equilibration period. Each femur was tested under five conditions: (a) intact, (b) after insertion of the long-stem intramedullary hip screw device, (c) with an experimentally created two-part fracture, (d) with a stable four-part fracture, and (e) with an unstable four-part fracture with the posteromedial fragment removed. Half the femurs were randomly assigned to have two distal interlocking screws placed before fracture. The remaining half were loaded without distal interlocking screws.(ABSTRACT TRUNCATED AT 250 WORDS)
