Park C G, Yoo J W, Park I C
Department of Plastic and Reconstructive Surgery, College of Medicine, Seoul National University, Korea.
Aesthetic Plast Surg. 1994 Fall;18(4):407-12. doi: 10.1007/BF00451349.
Mandibular prognathism is defined by John Hunter as follows: "The lower jaw projecting too far forward so that the foreteeth pass before those of the upper jaw, therefore disfigurement and malocclusion are two of the main facial characteristics." Other distinguishing features are the coexistence of class III malocclusion, incomplete closure of lip, deviation of the midline, and decrease of labiomental fold. Generally, the functional occlusal relationship and balanced facial harmony cannot be obtained by surgical or orthodontic treatment alone. Its success depends on careful conjoint, supplementary diagnostic, and treatment planning. As a cardinal principle the authors made the following combined surgical and orthodontic treatment plans: (1) Orthodontic treatment relocates and decompensates the malpositioned teeth (remove the masking effect of teeth) and, therefore, skeletal deformity is exposed maximally. (2) Surgical treatment eliminates the maximally exposed skeletal defect. Therefore, dramatic facial balance and functional occlusal relationship are obtained. Treatment planning includes the pre- and postoperative orthodontic treatment, lateral cephalometric prediction tracing (LCPT), and model surgery with dental cast. The authors made it easy with the use of an acrylic dental wafer to coordinate exact occlusal relationship after surgery. We treated mandibular prognathism by using Dautrey's modification of the sagittal split ramus osteotomy (SSRO) (10 cases) and intraoral vertical ramus osteotomy (IVRO) (5 cases) and sometimes additional genioplasty (2 cases). IVRO was used in those cases where (1) the amount of setback was more than 10 mm and (2) where there was a flat gonial angle.(ABSTRACT TRUNCATED AT 250 WORDS)
约翰·亨特对下颌前突的定义如下:“下颌过度向前突出,致使前牙位于上颌前牙之前,因此面部畸形和咬合不正成为主要的面部特征。”其他显著特征包括Ⅲ类错牙合、唇部闭合不全、中线偏移以及唇颏沟变浅。一般而言,单纯通过手术或正畸治疗无法实现功能性咬合关系及面部的平衡和谐。其成功取决于精心的联合、补充诊断及治疗方案规划。作为一项基本原则,作者制定了如下联合手术及正畸治疗方案:(1)正畸治疗可重新定位并矫正错位牙齿(消除牙齿的掩饰作用),从而最大程度地暴露骨骼畸形。(2)手术治疗可消除最大程度暴露的骨骼缺陷。因此,可实现显著的面部平衡及功能性咬合关系。治疗方案包括术前及术后正畸治疗、头颅侧位预测性描记(LCPT)以及牙模模型外科手术。作者借助丙烯酸牙托便于术后精确协调咬合关系。我们采用道特雷改良矢状劈开下颌升支截骨术(SSRO)(10例)、口内垂直下颌升支截骨术(IVRO)(5例),有时还辅助颏成形术(2例)治疗下颌前突。IVRO用于以下情况:(1)后推量超过10毫米;(2)下颌角较平缓。(摘要截选至250词)