Fleming B C, Beynnon B D, Nichols C E, Renström P A, Johnson R J, Pope M H
Department of Orthopaedics and Rehabilitation, McClure Musculoskeletal Research Center, University of Vermont College of Medicine, Burlington 05405.
J Bone Joint Surg Am. 1994 Apr;76(4):511-9. doi: 10.2106/00004623-199404000-00005.
This study was designed to determine if isometric measurement can be used to predict the pattern of elongation (the change in length) of a bone-patellar ligament-bone graft during passive flexion-extension of the knee at the time of reconstruction of the anterior cruciate ligament in vivo. A standard operative reconstruction technique was performed on nine patients. The tunnel sites for the grafts were selected, and the change in the distance between these sites was measured, with use of a CA-5000 drill-guide isometer as the knee was subjected to passive flexion-extension. After the reconstruction was completed, a Hall-effect transducer was implanted in the graft to measure the local displacement in the mid-substance of the graft that was produced by passive flexion-extension of the knee. For comparison, the isometric measurements and the values for local displacement of the graft were normalized by calculation of the percentage change in the length. With the knee in 10 to 30 degrees of flexion, the average isometric measurements and the measurements of local displacement demonstrated a decrease in length; however, the two techniques of measurement deviated at angles of flexion of 40 degrees and more. On the average, the isometric measurement of elongation between the trial insertion sites predicted that the graft would increase in length in flexion relative to extension, in contrast to the response of the graft after fixation. There was no significant correlation between the isometric measurements and the local elongation of the graft (r2 = 0.05).(ABSTRACT TRUNCATED AT 250 WORDS)
本研究旨在确定在体内重建前交叉韧带时,等长测量是否可用于预测骨-髌腱-骨移植物在膝关节被动屈伸过程中的伸长模式(长度变化)。对9例患者实施了标准的手术重建技术。选定移植物的隧道位置,在膝关节进行被动屈伸时,使用CA - 5000钻导式等长仪测量这些位置之间距离的变化。重建完成后,在移植物中植入霍尔效应传感器,以测量膝关节被动屈伸所产生的移植物中部的局部位移。为作比较,通过计算长度的百分比变化对等长测量值和移植物局部位移值进行标准化。膝关节处于10至30度屈曲时,平均等长测量值和局部位移测量值显示长度减小;然而,两种测量技术在40度及以上的屈曲角度时出现偏差。平均而言,试验植入部位之间伸长的等长测量预测,相对于伸展,移植物在屈曲时长度会增加,这与固定后移植物的反应相反。等长测量值与移植物局部伸长之间无显著相关性(r2 = 0.05)。(摘要截选至250词)