Distal movement of buccal segments with the "en masse" removable appliance: its value in treating patients with mild Class II, Division 1 malocclusion. Part II: the model measuring system and results.

The model of 25 children with mild Class II, Division 1 malocclusions who had their upper buccal segments moved distally with an en masse appliance were measured at the beginning of treatment and at the completion of buccal segment retraction. A reflex microscope, interfaced to a personal computer, was adapted for this purpose. A custom-made jig and linear stepping motor permitted the recording of both buccal and incisal measurements of the teeth in occlusion, as well as individual arch parameters. Software was designed to record and calculate the required measurements. The method error associated with this approach ranged from 0.01 to 0.5 mm. Results indicated that mean distal movement of the buccal segments approximated 6 mm, equivalent to a full cusp of buccal segment retraction. A small spontaneous reduction in overjet was seen. The upper arch showed spontaneous alignment and increases in width, length, and perimeter. In the lower jaw, transverse expansion was accompanied by a small increase in arch perimeter. Arch length, however, was slightly reduced. It was concluded that the system was an acceptable method of recording occlusal changes during orthodontic treatment, supplementing routine cephalometry. Furthermore, a full unit of buccal segment retraction could be expected, by using a removable appliance/headgear technique.