Lu Y, Nelsestuen G L
Department of Biochemistry, University of Minnesota, St. Paul, 55108, USA.
Biochemistry. 1996 Jun 25;35(25):8201-9. doi: 10.1021/bi960281g.
Kinetic properties of prothrombinase were investigated as a function of composition and structure of the membrane component. The kinetic properties were quite diverse, giving linear or nonlinear Eadie-Hofstee plots and substrate concentrations at half-maximum velocity ([S]0.5) that varied from 5 to more than 200 nM. This reaction might be described as a "catalytic system" in order to distinguish it from standard models that have been developed to describe the kinetics of soluble enzymes. The latter do not anticipate a key feature of prothrombinase and probably other membrane-bound enzymes, which is the presence of reaction steps that do not contain an enzyme (E) term. At least four kinetic mechanisms can arise from a logical series of steps that may occur during the prothrombinase reaction. All of these mechanisms appeared to contribute to reaction properties under some conditions. In some cases, one mechanism dominated at low substrate concentration and another at high substrate concentration. This change in the course of a titration was referred to as "mechanism switching". Only membranes of low phosphatidylserine (PS) content displayed Michaelis-Menten behavior. Transfer of substrate from the membrane surface to the enzyme was not important so that the enzyme was involved in capture of substrate directly from solution. As PS content increased, transfer of substrate from the membrane surface to the enzyme occurred. In these cases, multiple mechanisms contributed to the reaction so that K(M) and apparent K(M), properties that describe an enzyme active site, were not appropriate, even when Eadie-Hofstee plots were linear. At high PS content, the enzyme captured every substrate molecule that became bound to the same vesicle. Reaction velocity was governed entirely by protein-membrane binding rather than by enzyme properties. Eadie-Hofstee plots were often nonlinear and/or V(max) was less than kcat[E1]. A small impact from collision-limited kinetics was also detected. Small unilamellar vesicles (SUV, 30 nm diameter) gave higher [S]0.5 values than large unilamellar vesicles (LUV, 100 nm diameter) of the same phospholipid composition. There appeared to be two bases for this behavior. First, LUV may provide a better relationship between the phospholipid surface and the enzyme, giving a better substrate binding site. Second, for membranes containing high PS, the number of substrate binding sites per vesicle contributed to the enhanced function of LUV. These studies showed that mechanism-switching was important to prothrombinase reaction in vitro and suggest that various mechanisms, generated by the nature of the membrane, may be an important regulator for prothrombinase behavior in vivo.
研究了凝血酶原酶的动力学性质与膜成分的组成和结构之间的关系。其动力学性质差异很大,Eadie-Hofstee图呈线性或非线性,半数最大反应速度时的底物浓度([S]0.5)在5至200 nM以上变化。为了将该反应与已开发用于描述可溶性酶动力学的标准模型区分开来,可将其描述为“催化系统”。后者没有考虑到凝血酶原酶以及可能其他膜结合酶的一个关键特征,即存在不包含酶(E)项的反应步骤。凝血酶原酶反应过程中可能发生的一系列逻辑步骤至少会产生四种动力学机制。在某些条件下,所有这些机制似乎都对反应特性有贡献。在某些情况下,一种机制在低底物浓度下起主导作用,另一种在高底物浓度下起主导作用。滴定过程中的这种变化被称为“机制转换”。只有低磷脂酰丝氨酸(PS)含量的膜表现出米氏行为。底物从膜表面向酶的转移并不重要,因此酶直接从溶液中捕获底物。随着PS含量增加,底物从膜表面向酶发生转移。在这些情况下,多种机制对反应有贡献,因此即使Eadie-Hofstee图呈线性,描述酶活性位点的K(M)和表观K(M)性质也不合适。在高PS含量时,酶捕获了每个与同一囊泡结合的底物分子。反应速度完全由蛋白质-膜结合而非酶的性质决定。Eadie-Hofstee图通常是非线性的和/或V(max)小于kcat[E1]。还检测到碰撞限制动力学的微小影响。相同磷脂组成的小单层囊泡(SUV,直径30 nm)比大单层囊泡(LUV,直径100 nm)的[S]0.5值更高。这种行为似乎有两个原因。首先,LUV可能在磷脂表面与酶之间提供更好的关系,从而提供更好的底物结合位点。其次,对于含有高PS的膜,每个囊泡的底物结合位点数量有助于增强LUV的功能。这些研究表明机制转换对体外凝血酶原酶反应很重要,并表明由膜的性质产生的各种机制可能是体内凝血酶原酶行为的重要调节因子。