Havig M T, Kumar A, Carpenter W, Seiler J G
Department of Orthopaedic Surgery, Emory University School of Medicine, Atlanta, Georgia 30322, USA.
J Bone Joint Surg Am. 1997 Mar;79(3):428-32.
A study was undertaken to investigate the precision of plain radiographs in the assessment of the width of radiolucent lines and to define parameters for more accurate measurement. A metal-backed glenoid component was inserted into fourteen cadaveric scapulae; the component had a radiolucent spacer at the central post to provide a gap with a known width at the component-bone interface. The specimens were mounted in a custom-designed jig, and initial radiographs were made with the glenoid in neutral version; sequential radiographs then were made, at 5-degree intervals, with the glenoid in 0 to 40 degrees of anteversion and retroversion. Four independent observers with various levels of experience measured the width of the radiolucent lines with use of digital microcalipers. Osteometric analysis demonstrated that normal glenoid version ranged from 3 degrees of anteversion to 13 degrees of retroversion; these values were similar to those reported in previous studies. Radiographic analysis showed that accurate measurement of the width of the gap was dependent on the position of the glenoid. The measured widths of the radiolucent lines were significantly smaller than the known width of the gap when retroversion was 10 degrees or more and when anteversion was 15 degrees or more (p < or = 0.05). Radiolucent lines were not consistently observed on radiographs that were made with the glenoid in more than 20 degrees of anteversion and retroversion. An analysis of interobserver error showed close agreement among the measurements made by the different observers when the glenoid was in 0 and 5 degrees of rotation, with decreased agreement when the glenoid was rotated more than 10 degrees from neutral.
Inaccurate positioning of the patient and anatomical variation in glenoid version may explain the variability in the reported onsets, progressions, and frequencies of radiographic loosening of glenoid components. The findings of the present study also may help to explain the poor association between clinical and radiographic findings reported for patients who have pain at the site of a total shoulder prosthesis. Radiographs made within 10 degrees of neutral should allow accurate assessment of radiolucent lines about the glenoid.
进行了一项研究,以调查普通X线片在评估透亮线宽度方面的准确性,并确定更准确测量的参数。将一个金属背板的关节盂部件插入14个尸体肩胛骨中;该部件在中央柱处有一个透亮间隔物,以在部件与骨界面处提供一个已知宽度的间隙。将标本安装在定制设计的夹具中,最初的X线片是在关节盂处于中立位时拍摄的;然后以5度间隔依次拍摄关节盂处于0至40度前倾角和后倾角时的X线片。四名经验水平各异的独立观察者使用数字游标卡尺测量透亮线的宽度。骨测量分析表明,正常关节盂前倾角范围为3度至后倾角13度;这些值与先前研究报告的值相似。影像学分析表明,间隙宽度的准确测量取决于关节盂的位置。当后倾角为10度或更大以及前倾角为15度或更大时,测得的透亮线宽度明显小于间隙的已知宽度(p≤0.05)。当关节盂前倾角和后倾角超过20度时,X线片上不能始终观察到透亮线。观察者间误差分析表明,当关节盂处于0度和5度旋转时,不同观察者的测量结果一致性良好,而当关节盂从中立位旋转超过10度时,一致性降低。
患者定位不准确和关节盂版本的解剖变异可能解释了关节盂部件影像学松动的报告发病、进展和频率的变异性。本研究结果也可能有助于解释全肩关节假体部位疼痛患者临床和影像学表现之间关联不佳的原因。在中立位10度范围内拍摄的X线片应能准确评估关节盂周围的透亮线。