Suppr超能文献

生物药剂学药物分类及缓释(ER)制剂中使用的药物。

The biopharmaceutic drug classification and drugs administered in extended release (ER) formulations.

作者信息

Corrigan O I

机构信息

Department of Pharmaceutics, University of Dublin Trinity College, Ireland.

出版信息

Adv Exp Med Biol. 1997;423:111-28. doi: 10.1007/978-1-4684-6036-0_9.

Abstract

A biopharmaceutic drug classification scheme for correlating the in-vitro drug product dissolution and in-vivo bioavailability for IR products was proposed by Amidon et al (1995). The classification arose from drug dissolution and absorption models which identified the key parameters controlling drug absorption as the dimensionless numbers; the Absorption number (A(n)), the Dissolution number (Dn) and the Dose number (D(o)). This led to a biopharmaceutic classification of drugs into four groups, the establishment of a basis for determining the conditions under which in-vitro-in-vivo (IVIV) correlation's are expected and the use of the classification to set drug bioavailability standards for IR products. These developments raise the issue of whether the biopharmaceutic classification has relevance to ER products. In contrast to IR products, drugs selected for ER products should have good gastrointestinal (GI) permeability and an extended site of absorption. However their permeability(Papp) may change depending on the site. Solubility(Cs), effective fluid volume and hence D(o) may also vary with site. Of particular relevance to both permeability and solubility is the degree of ionization of the drug. Residence time at each site, pH changes and the potential for drug degradation at different sites, the latter resulting in a restricted absorption window, will influence the time frame over which an IVIV relationship is possible. Of the drugs available in ER dosage forms approximately 63% are bases, 15% acids and the remainder either unionizable or small inorganic ions. Acidic drugs will tend to have lower solubility's high up in the gastrointestinal tract (GIT), with solubility increasing down the GIT. In contrast with increased ionization permeability should fall. Thus with acids, as the dosage form moves to a more alkaline environment down the GIT, absorption may change from dissolution control to membrane control depending on the pK.a of the drug. In contrast bases will loose solubility with transit down the GIT, but become more permeable; absorption becoming more dissolution/release controlled or in extreme cases solubility controlled in the latter stages of the absorption phase. In the light of the above considerations a modified biopharmaceutic classification is proposed for ER products.

摘要

阿米登等人(1995年)提出了一种生物药剂学药物分类方案,用于关联速释产品的体外药物溶出度和体内生物利用度。该分类源自药物溶出和吸收模型,这些模型将控制药物吸收的关键参数确定为无量纲数:吸收数(A(n))、溶出数(Dn)和剂量数(D(o))。这导致将药物进行生物药剂学分类,分为四类,为确定预期体外-体内(IVIV)相关性的条件奠定了基础,并利用该分类为速释产品设定药物生物利用度标准。这些进展引发了生物药剂学分类是否与缓释产品相关的问题。与速释产品不同,选择用于缓释产品的药物应具有良好的胃肠道(GI)渗透性和扩展的吸收部位。然而,它们的渗透率(Papp)可能会因部位而异。溶解度(Cs)、有效流体体积以及因此的D(o)也可能随部位而变化。与渗透性和溶解度特别相关的是药物的电离程度。在每个部位的停留时间、pH变化以及不同部位药物降解的可能性(后者导致吸收窗口受限),都会影响建立IVIV关系的时间范围。在缓释剂型中可用的药物中,约63%为碱,15%为酸,其余为不可电离的或小的无机离子。酸性药物在胃肠道(GIT)上部往往具有较低的溶解度,随着在GIT中向下移动溶解度增加。与之相反,随着电离增加,渗透率应下降。因此,对于酸来说,随着剂型在GIT中向下移动到更碱性的环境,根据药物的pK.a,吸收可能从溶出控制转变为膜控制。相比之下,碱在通过GIT时会失去溶解度,但会变得更具渗透性;吸收在吸收阶段的后期变得更多地受溶出/释放控制,在极端情况下受溶解度控制。鉴于上述考虑因素,提出了一种针对缓释产品的改良生物药剂学分类。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验