Suppr超能文献

变构腺苷单磷酸核苷酶的初始速度和结合数据比较。

Comparison of initial velocity and binding data for allosteric adenosine monophosphate nucleosidase.

作者信息

Schramm V L

出版信息

J Biol Chem. 1976 Jun 10;251(11):3417-24.

PMID:931993
Abstract

Adensine monophosphate nucleosidase (AMP nucleosidase) from Azotobacter vinelandii is composed of six subunits with similar or identical charge and size and has a molecular weight of approximately 320,000. Binding studies with tritiated tubercidin 5' -PO4 (4-amino-7-(beta-D-ribofuranosyl)pyrrolo[2,3-d]pyrimidine-5' -monophosphate), a competitive inhibitor with respect to the substrate, AMP, indicate the presence of three independent, identical binding sites for the substrate analog. The binding of tubercidin 5' -PO4 is not affected by either Mg2+ or MgATP2-; however, in initial velocity experiments MgATP2- caused from greater than100- to 4,000-fold activation of substrate hydrolysis depending on the concentration of AMP. Binding studies with [14C]ATP are consistent with six interdependent binding sites for MgAT2-. Initial velocity and binding curves for MgATP2- are similar in shape, but reveal a disproportionate increase in initial velocity at low saturation levels of MgAT2-. Binding of MgAT2- is inhibited by increasing concentrations of P1 which acts as a competitive inhibitor of MgATP2- activation in both initial velocity and binding experiments. In the absence of MgATP2-, 32Pi binds at six or more interdependent modifier sites. The simulataneous binding of Mg[14C]ATP2- and 32Pi was studied in experiments where MgATP2- and Pi were held in constant ratio. Extrapolation to infinite concentrations of both MgATP2- and Pi indicated that 3 molecules of each were bound to the enzyme. Thus the binding of the allosteric activator and inhibitor are mutually exclusive. These results are consistent with a single modifier site per subunit at which either MgATP2- or Pi may combine, or with separate activator and inhibitor sites which cannot be filled simultaneously. Comparative initial velocity and binding studies with Pi indicate that the initial rate of AMP hydrolysis depends primarily on the extent of modifier site saturation with MgATP2-. Thus when two sites are filled with MgATP2-, the initial rate is approximately the same as when two additional modifier sites are filled with Pi. Binding of Pi, therefore, does not appear to affect the catalytic effectiveness of the active site when MgATP2- is also present, except by the displacement of MgATP2-.

摘要

来自棕色固氮菌的腺苷单磷酸核苷酶(AMP核苷酶)由六个电荷和大小相似或相同的亚基组成,分子量约为320,000。用氚标记的结核菌素5'-PO4(4-氨基-7-(β-D-呋喃核糖基)吡咯并[2,3-d]嘧啶-5'-单磷酸)进行的结合研究表明,对于底物AMP存在三个独立、相同的底物类似物结合位点。结核菌素5'-PO4的结合不受Mg2+或MgATP2-的影响;然而,在初速度实验中,MgATP2-根据AMP的浓度导致底物水解的激活倍数大于100至4000倍。用[14C]ATP进行的结合研究与MgAT2-的六个相互依赖的结合位点一致。MgATP2-的初速度和结合曲线形状相似,但在MgAT2-低饱和度水平下初速度有不成比例的增加。MgAT2-的结合受到P1浓度增加的抑制,P1在初速度和结合实验中均作为MgATP2-激活的竞争性抑制剂。在没有MgATP2-的情况下,32Pi在六个或更多相互依赖的调节位点结合。在MgATP2-和Pi保持恒定比例的实验中研究了Mg[14C]ATP2-和32Pi的同时结合。外推到MgATP2-和Pi的无限浓度表明,每种物质的3个分子与酶结合。因此,变构激活剂和抑制剂的结合是相互排斥的。这些结果与每个亚基有一个单一的调节位点一致,在该位点MgATP2-或Pi可以结合,或者与不能同时被占据的单独的激活剂和抑制剂位点一致。与Pi的比较初速度和结合研究表明,AMP水解的初始速率主要取决于调节位点被MgATP2-饱和的程度。因此,当两个位点被MgATP2-占据时,初始速率与另外两个调节位点被Pi占据时大致相同。因此,当MgATP2-也存在时,Pi的结合似乎不会影响活性位点的催化效率,除非MgATP2-被取代。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验