Lieber R L
Department of Orthopaedics, University of California, San Diego, USA.
Acta Anat (Basel). 1997;159(2-3):84-9. doi: 10.1159/000147970.
The purpose of this study was to test the hypothesis that muscle fiber length and joint moment arm are combined in such a way that maximum muscle force is produced during locomotion. Plantarflexor (soleus, SOL and medial gastrocnemius, MG) and dorsiflexor (extensor digitorum longus, EDL and tibialis anterior, TA) muscle architecture in the mouse was measured along with their associated moment arms. Fiber length varied significantly between muscles ranging from 5.7 +/- 0.2 mm (MG) to 7.6 +/- 0.2 mm (TA). Plantarflexor moment arms were over twice as large as dorsiflexor moment arms (1.88 +/- 0.06 mm vs. 0.84 +/- 0.03 mm) suggesting a greater muscle length change with joint angle for plantarflexors compared to dorsiflexors. Using a simple muscle-joint model, the active sarcomere length range in these muscle groups was calculated and proved to be quite similar between functional groups. The active range for dorsiflexors was 2.2-2.4 microns, while the active range for plantarflexors was 2.2-2.5 microns, indicating that both muscle groups operate primarily near the plateau of their length tension-relation. Finally, when calculating force produced by muscles during locomotion, the combination of moment arm and fiber length measured in all muscle groups yielded muscle-joint systems that produced near maximal forces at the velocities modeled. These data indicate that fiber length and moment arm appear to be coordinated to yield the greatest possible force production during locomotion.
肌肉纤维长度和关节力臂以某种方式结合,使得在运动过程中产生最大肌肉力量。测量了小鼠的跖屈肌(比目鱼肌,SOL和内侧腓肠肌,MG)和背屈肌(趾长伸肌,EDL和胫骨前肌,TA)的肌肉结构及其相关的力臂。肌肉之间的纤维长度差异显著,范围从5.7±0.2毫米(MG)到7.6±0.2毫米(TA)。跖屈肌的力臂比背屈肌的力臂大两倍多(1.88±0.06毫米对0.84±0.03毫米),这表明与背屈肌相比,跖屈肌随关节角度的肌肉长度变化更大。使用简单的肌肉-关节模型,计算了这些肌肉群中的活性肌节长度范围,结果证明功能组之间非常相似。背屈肌的活性范围为2.2-2.4微米,而跖屈肌的活性范围为2.2-2.5微米,这表明两个肌肉群主要在其长度-张力关系的平台附近起作用。最后,在计算运动过程中肌肉产生的力时,所有肌肉群中测量的力臂和纤维长度的组合产生了在模拟速度下产生接近最大力的肌肉-关节系统。这些数据表明,纤维长度和力臂似乎相互协调,以便在运动过程中产生尽可能大的力。