Troiano G C, Tung L, Sharma V, Stebe K J
Department of Biomedical Engineering, The Johns Hopkins University, Baltimore, Maryland 21205, USA.
Biophys J. 1998 Aug;75(2):880-8. doi: 10.1016/S0006-3495(98)77576-9.
The effects of a nonionic surfactant, octaethyleneglycol mono n-dodecyl ether (C12E8), on the electroporation of planar bilayer lipid membranes made of the synthetic lipid 1-pamitoyl 2-oleoyl phosphatidylcholine (POPC), was studied. High-amplitude ( approximately 100-450 mV) rectangular voltage pulses were used to electroporate the bilayers, followed by a prolonged, low-amplitude ( approximately 65 mV) voltage clamp to monitor the ensuing changes in transmembrane conductance. The electroporation thresholds of the membranes were found for rectangular voltage pulses of given durations. The strength-duration relationship was determined over a range from 10 micros to 10 s. The addition of C12E8 at concentrations of 0.1, 1, and 10 microM to the bath surrounding the membranes decreased the electroporation threshold monotonically with concentration for all durations (p < 0.0001). The decrease from control values ranged from 10% to 40%, depending on surfactant concentration and pulse duration. For a 10-micros pulse, the transmembrane conductance 150 micros after electroporation (G150) increased monotonically with the surfactant concentration (p = 0.007 for 10 microM C12E8). These findings suggest that C12E8 incorporates into POPC bilayers, allowing electroporation at lower intensities and/or shorter durations, and demonstrate that surfactants can be used to manipulate the electroporation threshold of lipid bilayers.
研究了非离子表面活性剂八甘醇单正十二烷基醚(C12E8)对由合成脂质1-棕榈酰基-2-油酰基磷脂酰胆碱(POPC)制成的平面双层脂质膜电穿孔的影响。使用高幅度(约100 - 450 mV)的矩形电压脉冲对双层膜进行电穿孔,随后进行长时间的低幅度(约65 mV)电压钳制以监测跨膜电导的后续变化。针对给定持续时间的矩形电压脉冲,确定了膜的电穿孔阈值。在10微秒至10秒的范围内确定了强度 - 持续时间关系。向围绕膜的浴中添加浓度为0.1、1和10 microM的C12E8,在所有持续时间下,电穿孔阈值均随浓度单调降低(p < 0.0001)。与对照值相比的降低幅度在10%至40%之间,具体取决于表面活性剂浓度和脉冲持续时间。对于10微秒的脉冲,电穿孔后150微秒的跨膜电导(G150)随表面活性剂浓度单调增加(对于10 microM C12E8,p = 0.007)。这些发现表明C12E8可掺入POPC双层膜中,使得在较低强度和/或较短持续时间下实现电穿孔,并证明表面活性剂可用于操纵脂质双层膜的电穿孔阈值。