Schmidt J E, Ahring B K
The Anaerobic Microbiology/Biotechnology Research Group, Department of Environmental Science and Engineering, The Technical University of Denmark, DK-2800 Lyngby, Denmark.
Appl Environ Microbiol. 1999 Mar;65(3):1050-4. doi: 10.1128/AEM.65.3.1050-1054.1999.
Sterile granular sludge was inoculated with either Methanosarcina mazeii S-6, Methanosaeta concilii GP-6, or both species in acetate-fed upflow anaerobic sludge blanket (UASB) reactors to investigate the immobilization patterns and dynamics of aceticlastic methanogens in granular sludge. After several months of reactor operation, the methanogens were immobilized, either separately or together. The fastest immobilization was observed in the reactor containing M. mazeii S-6. The highest effluent concentration of acetate was observed in the reactor with only M. mazeii S-6 immobilized, while the lowest effluent concentration of acetate was observed in the reactor where both types of methanogens were immobilized together. No changes were observed in the kinetic parameters (Ks and mumax) of immobilized M. concilii GP-6 or M. mazeii S-6 compared with suspended cultures, indicating that immobilization does not affect the growth kinetics of these methanogens. An enzyme-linked immunosorbent assay using polyclonal antibodies against either M. concilii GP-6 or M. mazeii S-6 showed significant variations in the two methanogenic populations in the different reactors. Polyclonal antibodies were further used to study the spatial distribution of the two methanogens. M. concilii GP-6 was immobilized only on existing support material without any specific pattern. M. mazeii S-6, however, showed a different immobilization pattern: large clumps were formed when the concentration of acetate was high, but where the acetate concentration was low this strain was immobilized on support material as single cells or small clumps. The data clearly show that the two aceticlastic methanogens immobilize differently in UASB systems, depending on the conditions found throughout the UASB reactor.
在以乙酸为底物的上流式厌氧污泥床(UASB)反应器中,接种无菌颗粒污泥,分别接入马氏甲烷八叠球菌S-6、嗜乙酸甲烷丝菌GP-6或两种菌,以研究颗粒污泥中乙酸营养型产甲烷菌的固定化模式和动态变化。经过数月的反应器运行,产甲烷菌被单独或共同固定。在含有马氏甲烷八叠球菌S-6的反应器中观察到最快的固定化。在仅固定了马氏甲烷八叠球菌S-6的反应器中观察到乙酸的最高出水浓度,而在两种产甲烷菌共同固定的反应器中观察到乙酸的最低出水浓度。与悬浮培养相比,固定化的嗜乙酸甲烷丝菌GP-6或马氏甲烷八叠球菌S-6的动力学参数(Ks和μm ax)没有变化,表明固定化不影响这些产甲烷菌的生长动力学。使用针对嗜乙酸甲烷丝菌GP-6或马氏甲烷八叠球菌S-6的多克隆抗体进行的酶联免疫吸附测定显示,不同反应器中两种产甲烷菌群存在显著差异。多克隆抗体进一步用于研究两种产甲烷菌的空间分布。嗜乙酸甲烷丝菌GP-6仅固定在现有的载体材料上且无任何特定模式。然而,马氏甲烷八叠球菌S-6表现出不同的固定化模式:当乙酸浓度高时形成大的菌团,但在乙酸浓度低的地方,该菌株以单细胞或小菌团的形式固定在载体材料上。数据清楚地表明,在UASB系统中,两种乙酸营养型产甲烷菌的固定化方式不同,这取决于整个UASB反应器中的条件。