Jepsen K J, Davy D T, Krzypow D J
Department of Orthopaedics, Case Western Reserve University, Cleveland, OH 44106, USA.
J Biomech. 1999 Mar;32(3):303-10. doi: 10.1016/s0021-9290(98)00179-1.
Fragility fractures are a result of alterations in bone quantity, tissue properties, applied loads, or a combination of these factors. The current study addresses the contribution of cortical bone tissue properties to skeletal fragility by characterizing the shear damage accumulation processes which occur during torsional yielding in normal bone. Samples of human femoral cortical bone were loaded in torsion and damaged at a post-yield twist level. The number of microcracks within osteons, interstitial tissue, and along cement lines were assessed using basic fuchsin staining. Damage density measures (number of cracks/mm2) were correlated with stiffness degradation and changes in relaxation. Damaged samples exhibited a wide variation in total microcrack density, ranging from 1.1 to 43.3 cracks/mm2 with a mean density of 19.7 +/- 9.8 cracks/mm2. Lamellar interface cracks comprised more than 75% of the total damage, indicating that the lamellar interface is weak in shear and is a principal site of shear damage accumulation. Damage density was positively correlated with secant stiffness degradation, but only explained 22% of the variability in degradation. In contrast, damage density was uncorrelated with the changes in relaxation, indicating that a simple crack counting measure such as microcrack density was not an appropriate measure of relaxation degradation. Finally, a nonuniform microcrack density distribution was observed, suggesting that internal shear stresses were redistributed within the torsion samples during post-yield loading. The results suggested that the lamellar interface in human cortical bone plays an important role in torsional yielding by keeping cracks physically isolated from each other and delaying microcrack coalescence in order to postpone the inevitable formation of the fatal crack.
脆性骨折是骨量、组织特性、施加负荷或这些因素综合作用发生改变的结果。本研究通过描述正常骨扭转屈服过程中发生的剪切损伤累积过程,探讨皮质骨组织特性对骨骼脆性的影响。对人股骨皮质骨样本进行扭转加载,并在屈服后扭转水平下造成损伤。使用碱性品红染色评估骨单位内、间质组织以及沿黏合线的微裂纹数量。损伤密度测量值(裂纹数/mm²)与刚度降解和松弛变化相关。受损样本的总微裂纹密度差异很大,范围为1.1至43.3裂纹/mm²,平均密度为19.7±9.8裂纹/mm²。板层界面裂纹占总损伤的75%以上,表明板层界面在剪切力作用下较弱,是剪切损伤累积的主要部位。损伤密度与割线刚度降解呈正相关,但仅解释了降解变异性的22%。相比之下,损伤密度与松弛变化无关,这表明诸如微裂纹密度这样简单的裂纹计数测量方法并非评估松弛降解的合适方法。最后,观察到微裂纹密度分布不均匀,这表明在屈服后加载过程中,内部剪应力在扭转样本内重新分布。结果表明,人类皮质骨中的板层界面在扭转屈服中起着重要作用,它使裂纹彼此物理隔离并延迟微裂纹合并,从而推迟致命裂纹的不可避免形成。