Fjeld C C, Denu J M
Department of Biochemistry and Molecular Biology, Oregon Health Sciences University, Portland, OR 97201-3098, USA.
J Biol Chem. 1999 Jul 16;274(29):20336-43. doi: 10.1074/jbc.274.29.20336.
The PPM family of Ser/Thr protein phosphatases have recently been shown to down-regulate the stress response pathways in eukaryotes. Within the stress pathway, key signaling kinases, which are activated by protein phosphorylation, have been proposed as the in vivo substrates of PP2C, the prototypical member of the PPM family. Although it is known that these phosphatases require metal cations for activity, the molecular details of these important reactions have not been established. Therefore, here we report a detailed biochemical study to elucidate the kinetic and chemical mechanism of PP2Calpha. Steady-state kinetic and product inhibition studies revealed that PP2Calpha employs an ordered sequential mechanism, where the metal cations bind before phosphorylated substrate, and phosphate is the last product to be released. The metal-dependent activity of PP2C (as reflected in kcat and kcat/Km), indicated that Fe2+ was 1000-fold better than Mg2+. The pH rate profiles revealed two ionizations critical for catalytic activity. An enzyme ionization with a pKa value of 7 must be unprotonated for catalysis, and an enzyme ionization with a pKa of 9 must be protonated for substrate binding. Brönsted analysis of substrate leaving group pKa indicated that phosphomonoester hydrolysis is rate-limiting at pH 7. 0, but not at pH 8.5 where a common step independent of the nature of the substrate and alcohol product limits turnover (kcat). Rapid reaction kinetics between phosphomonoester and PP2C yielded exponential "bursts" of product formation, consistent with phosphate release being the slow catalytic step at pH 8.5. Dephosphorylation of synthetic phosphopeptides corresponding to several protein kinases revealed that PP2C displays a strong preference for diphosphorylated peptides in which the phosphorylated residues are in close proximity.
丝氨酸/苏氨酸蛋白磷酸酶的PPM家族最近被证明可下调真核生物中的应激反应途径。在应激途径中,由蛋白质磷酸化激活的关键信号激酶被认为是PPM家族的典型成员PP2C在体内的底物。尽管已知这些磷酸酶的活性需要金属阳离子,但这些重要反应的分子细节尚未确定。因此,我们在此报告一项详细的生化研究,以阐明PP2Cα的动力学和化学机制。稳态动力学和产物抑制研究表明,PP2Cα采用有序的顺序机制,其中金属阳离子在磷酸化底物之前结合,而磷酸盐是最后释放的产物。PP2C的金属依赖性活性(反映在kcat和kcat/Km中)表明,Fe2+比Mg2+好1000倍。pH速率曲线揭示了对催化活性至关重要的两个电离。催化作用时,pKa值为7的酶电离必须未质子化,而底物结合时,pKa为9的酶电离必须质子化。对底物离去基团pKa的布朗斯特分析表明,磷酸单酯水解在pH 7.0时是限速步骤,但在pH 8.5时不是,在pH 8.5时,一个与底物和醇产物性质无关的共同步骤限制了周转(kcat)。磷酸单酯与PP2C之间的快速反应动力学产生了产物形成的指数“爆发”,这与磷酸盐释放是pH 8.5时的慢催化步骤一致。对几种蛋白激酶对应的合成磷酸肽的去磷酸化表明,PP2C对磷酸化残基紧密相邻的双磷酸化肽表现出强烈偏好。