Suppr超能文献

评估吸入药物在肺部的沉积。英国肺部研究协会研讨会的共识声明,于1998年4月17日在英国伦敦生物研究所举行。

Assessing lung deposition of inhaled medications. Consensus statement from a workshop of the British Association for Lung Research, held at the Institute of Biology, London, U.K. on 17 April 1998.

作者信息

Snell N J, Ganderton D

机构信息

Bayer European Medical Affairs Group, Stoke Poges, U.K.

出版信息

Respir Med. 1999 Feb;93(2):123-33. doi: 10.1016/s0954-6111(99)90302-5.

Abstract

In vitro measurements of aerosol fine particle fraction (FPF) using particle-sizing apparatus (e.g. the twin impinger, multi-stage liquid impingers, cascade impactors) have a key role to play in the development of new pharmaceutical products and in quality control. However, use of in vitro methodology to attempt to predict lung deposition in vivo is of limited value due, in part, to the inability of current apparatus to mimic upper and lower airway anatomy satisfactorily. Estimates of FPF based on cut-off points ranging from 5-7 microns generally overestimate lung deposition as measured in vivo by gamma scintigraphy. We recommend that: 1. multistage apparatus (minimum five stages) be used to characterize particle size distribution adequately, over the range 0.5-5.0 microns; 2. where possible, measurements should be made at a range of rates and profiles of flow reflecting those likely to be generated using the inhalation device in clinical practice (including use by young and elderly patients with varying degrees of airflow obstruction); 3. encouragement should be given to the further development, standardization, and validation of apparatus with a 'throat' which more closely resembles the human oropharynx and larynx. Pharmacokinetic methods can give a good estimate of total, but not regional, lung deposition, with drugs which are either not absorbed via the gastrointestinal tract, or whose absorption can be blocked by co-administration of charcoal, thus avoiding confounding by absorption of drug substance deposited in the oropharynx and subsequently swallowed. Techniques which rely on evaluation of a timed fractional output of drug substance in the urine are susceptible to the inherent variability of rate of absorption across the respiratory epithelium. We recommend that consideration should be given to the further refinement and validation of PK methods which would more clearly identify the fractional dose deposited in the lung. Lung-imaging methodology, e.g. gamma scintigraphy, employing formulations radiolabelled with gamma-ray-emitting radionuclides such as 99mTc, can measure total lung deposition and oropharyngeal deposition, provided that the radiolabelling process is appropriately validated and suitable corrections are made for attenuation of gamma rays by body tissues. An estimate of regional lung deposition can be made by drawing 'regions of interest' on the scintigraphic image; the precision of this measure is limited by the two-dimensional (2-D) nature of most images which mean that there is an overlay of structures of interest (alveoli, small and large airways), which is most marked centrally. Three-dimensional (3-D) imaging techniques (e.g. single photon emission computed tomography, SPECT, and positron emission tomography, PET) have the potential to give more detailed data on regional lung deposition, but are currently more expensive, employ higher radiation doses, and are less well validated than 2-D (planar) imaging. We consider that, of the available imaging modalities, planar gamma scintigraphy represents current best practice for the assessment of lung deposition from inhaler devices where regional differences may be important. The methodology should be optimized by the adoption of generally accepted standards for radiolabelling, imaging, attenuation correction, and interpretation. It is important that deposition in all sites (device, oropharynx, lungs, stomach) should be quantified. Consideration should be given to refining the concept of regions of interest to coincide more closely with anatomical lung structures. Statistical methods to compare the size distributions of drug and radiolabel in validation experiments should be developed. In the longer term it is envisaged that three-dimensional imaging may play a more important part in evaluating lung deposition; an optimal three-dimensional anatomical model of lung zones of interest needs to be developed.

摘要

使用颗粒大小测定仪器(如双撞击器、多级液体撞击器、级联冲击器)对气溶胶细颗粒分数(FPF)进行体外测量,在新药品研发和质量控制中起着关键作用。然而,使用体外方法试图预测体内肺部沉积的价值有限,部分原因是目前的仪器无法令人满意地模拟上、下气道解剖结构。基于5至7微米截断点的FPF估计值通常高估了通过γ闪烁显像在体内测量的肺部沉积。我们建议:1. 使用多级仪器(至少五级),以充分表征0.5至5.0微米范围内的颗粒大小分布;2. 尽可能在一系列反映临床实践中使用吸入装置可能产生的流速和流量曲线下进行测量(包括不同程度气流阻塞的年轻和老年患者使用时);3. 应鼓励进一步开发、标准化和验证带有更接近人类口咽和喉部的“喉”的仪器。药代动力学方法可以很好地估计肺部的总沉积量,但不能估计局部沉积量,对于那些不通过胃肠道吸收或其吸收可通过同时给予木炭来阻断的药物来说是这样,从而避免了沉积在口咽中随后被吞咽的药物物质吸收造成的混淆。依赖评估尿液中药物物质定时分数输出的技术易受跨呼吸上皮吸收速率固有变异性的影响。我们建议应考虑进一步完善和验证药代动力学方法,以便更清楚地识别沉积在肺部的分数剂量。肺部成像方法,如γ闪烁显像,采用用发射γ射线的放射性核素(如99mTc)进行放射性标记的制剂,只要放射性标记过程得到适当验证,并对身体组织对γ射线的衰减进行适当校正,就可以测量肺部总沉积量和口咽沉积量。通过在闪烁显像图像上绘制“感兴趣区域”可以估计局部肺部沉积量;该测量的精度受到大多数图像二维(2-D)性质的限制,这意味着感兴趣的结构(肺泡、大小气道)存在重叠,在中央最为明显。三维(3-D)成像技术(如单光子发射计算机断层扫描、SPECT和正电子发射断层扫描、PET)有可能提供关于局部肺部沉积的更详细数据,但目前比二维(平面)成像更昂贵,使用的辐射剂量更高,且验证程度较低。我们认为,在可用的成像方式中,平面γ闪烁显像代表了评估吸入装置肺部沉积的当前最佳实践,其中局部差异可能很重要。应通过采用放射性标记、成像、衰减校正和解释的普遍接受标准来优化该方法。对所有部位(装置、口咽、肺部、胃部)的沉积进行量化很重要。应考虑完善感兴趣区域的概念,使其更紧密地与肺部解剖结构一致。应开发用于比较验证实验中药物和放射性标记大小分布的统计方法。从长远来看,预计三维成像在评估肺部沉积方面可能发挥更重要的作用;需要开发感兴趣的肺部区域的最佳三维解剖模型。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验