Gardiner G E, O'Sullivan E, Kelly J, Auty M A, Fitzgerald G F, Collins J K, Ross R P, Stanton C
Teagasc, Dairy Products Research Center, Moorepark, Fermoy, County Cork, Ireland.
Appl Environ Microbiol. 2000 Jun;66(6):2605-12. doi: 10.1128/AEM.66.6.2605-2612.2000.
Spray drying of skim milk was evaluated as a means of preserving Lactobacillus paracasei NFBC 338 and Lactobacillus salivarius UCC 118, which are human-derived strains with probiotic potential. Our initial experiments revealed that NFBC 338 is considerably more heat resistant in 20% (wt/vol) skim milk than UCC 118 is; the comparable decimal reduction times were 11.1 and 1.1 min, respectively, at 59 degrees C. An air outlet temperature of 80 to 85 degrees C was optimal for spray drying; these conditions resulted in powders with moisture contents of 4.1 to 4.2% and viable counts of 3.2 x 10(9) CFU/g for NFBC 338 and 5.2 x 10(7) CFU/g for UCC 118. Thus, L. paracasei NFBC 338 survived better than L. salivarius UCC 118 during spray drying; similar results were obtained when we used confocal scanning laser microscopy and LIVE/DEAD BacLight viability staining. In addition, confocal scanning laser microscopy revealed that the probiotic lactobacilli were located primarily in the powder particles. Although both spray-dried cultures appeared to be stressed, as shown by increased sensitivity to NaCl, bacteriocin production by UCC 118 was not affected by the process, nor was the activity of the bacteriocin peptide. The level of survival of NFBC 338 remained constant at approximately 1 x 10(9) CFU/g during 2 months of powder storage at 4 degrees C, while a decline in the level of survival of approximately 1 log (from 7.2 x 10(7) to 9.5 x 10(6) CFU/g) was observed for UCC 118 stored under the same conditions. However, survival of both Lactobacillus strains during powder storage was inversely related to the storage temperature. Our data demonstrate that spray drying may be a cost-effective way to produce large quantities of some probiotic cultures.
对脱脂奶粉进行喷雾干燥,以此作为保存副干酪乳杆菌NFBC 338和唾液乳杆菌UCC 118的一种方法进行评估,这两种菌均为具有益生菌潜力的人源菌株。我们最初的实验表明,在20%(重量/体积)脱脂奶粉中,NFBC 338的耐热性比UCC 118强得多;在59℃时,相应的D值分别为11.1分钟和1.1分钟。80至85℃的出风口温度最适合喷雾干燥;这些条件下得到的粉末,NFBC 338的水分含量为4.1%至4.2%,活菌数为3.2×10⁹CFU/g,UCC 118的水分含量为4.1%至4.2%,活菌数为5.2×10⁷CFU/g。因此,在喷雾干燥过程中,副干酪乳杆菌NFBC 338比唾液乳杆菌UCC 118存活得更好;当我们使用共聚焦扫描激光显微镜和LIVE/DEAD BacLight活菌染色时,也得到了类似的结果。此外,共聚焦扫描激光显微镜显示,益生菌乳杆菌主要位于粉末颗粒中。尽管两种喷雾干燥培养物似乎都受到了压力,表现为对氯化钠的敏感性增加,但UCC 118产生细菌素的能力并未受到该过程的影响,细菌素肽的活性也未受影响。在4℃下储存2个月期间,NFBC 338的存活水平保持在约1×10⁹CFU/g不变,而在相同条件下储存的UCC 118的存活水平下降了约1个对数(从7.2×10⁷降至9.5×10⁶CFU/g)。然而,两种乳杆菌菌株在粉末储存期间的存活率与储存温度呈负相关。我们的数据表明,喷雾干燥可能是一种生产大量某些益生菌培养物的经济有效的方法。