Eggink F A, Beekhuis W H, Nuijts R M
Academic Hospital Maastricht, Department of Ophthalmology, The Netherlands.
Graefes Arch Clin Exp Ophthalmol. 2001 Jun;239(5):361-6. doi: 10.1007/s004170100282.
Laser in situ keratomileusis (LASIK) has recently become the most commonly performed refractive surgery procedure. Results are promising in correcting low to moderate myopia. Most complications occur during the surgeon's learning curve. One of the complications is a decentration of the ablated area that causes monocular diplopia and a nocturnal halo phenomenon due to a multifocality of the corneal surface overlying the entrance pupil. The corneal shape is significantly altered after LASIK. We evaluate the efficacy of rigid gas-permeable contact lens designs and fitting techniques used in eight eyes with multifocal LASIK ablations to correct haloes and impaired night vision complaints.
We used large-diameter tetra-curved rigid gas-permeable (RGP) contact lenses for visual recovery in eight eyes of seven LASIK patients. We used the power on the transition zone of the corneal topographic map, 0.2 mm outside the ablated refractive area, for selection of the back optic zone radius of the RGP contact lenses. Procedures for lens fitting are described. Visual acuity (high-contrast logarithm of the minimum angle of resolution, LogMAR) was measured before- and 6 months after contact lens fitting.
Large-diameter tetra-curve RGP lenses with a mean diameter of 11.85 (SD 0.16) mm were successfully used in LASIK patients with multifocal corneas. Mean best spectacle-corrected visual acuity was +0.3 LogMAR (SD 0.19; in Snellen equivalent, 20/40) and improved significantly with the contact lenses to +0.08 LogMAR (SD 0.11; in Snellen equivalent, 20/25, P=<0.01). During the follow-up period of 16.7 months, the average daily wearing time of the lenses was 12.5 h. Contact lenses with a standard geometry were not useful due to excessive movement and inadequate centration.
Contact lenses with large diameters, in combination with selection of the back optic zone radius 0.2 mm peripheral of the refractive ablation zone, facilitate contact lens fitting to restore best-corrected visual acuity in LASIK patients with multifocal corneas.
准分子原位角膜磨镶术(LASIK)近来已成为最常用的屈光手术。在矫正低度至中度近视方面效果良好。大多数并发症出现在外科医生的学习曲线阶段。并发症之一是消融区偏心,由于覆盖入瞳的角膜表面多焦性导致单眼复视和夜间光晕现象。LASIK术后角膜形状会发生显著改变。我们评估了用于8只接受多焦点LASIK消融术眼睛的硬性透气性接触镜设计及验配技术在矫正光晕和改善夜视力主诉方面的效果。
我们使用大直径四环曲面硬性透气性(RGP)接触镜使7例LASIK患者的8只眼睛恢复视力。我们采用角膜地形图过渡区的屈光度,即在消融屈光区外0.2 mm处,来选择RGP接触镜的后光学区半径。描述了镜片验配程序。在接触镜验配前及验配6个月后测量视力(最小分辨角的高对比度对数,LogMAR)。
平均直径为11.85(标准差0.16)mm的大直径四环曲面RGP镜片成功用于多焦点角膜的LASIK患者。平均最佳矫正视力为+0.3 LogMAR(标准差0.19;Snellen等效值为20/40),佩戴接触镜后显著改善至+0.08 LogMAR(标准差0.11;Snellen等效值为20/25,P<0.01)。在16.7个月的随访期内,镜片平均每日佩戴时间为12.5小时。标准几何形状的接触镜因移动过多和定位不佳而无用。
大直径接触镜,结合在屈光消融区周边0.2 mm处选择后光学区半径,有助于验配接触镜,以恢复多焦点角膜LASIK患者的最佳矫正视力。