Suppr超能文献

细菌对表面亲水和疏水隐形眼镜的粘附

Bacterial adhesion to surface hydrophilic and hydrophobic contact lenses.

作者信息

Bruinsma G M, van der Mei H C, Busscher H J

机构信息

Department of Biomedical Engineering, University of Groningen, The Netherlands.

出版信息

Biomaterials. 2001 Dec;22(24):3217-24. doi: 10.1016/s0142-9612(01)00159-4.

Abstract

The aim of this paper was to determine the adhesion of two physico-chemically characterized bacterial strains to a surface hydrophilic (CL A, water contact angle 57 degrees) and hydrophobic (CL B, water contact angle 106 degrees) hydrogel contact lens (CL) with and without an adsorbed tear film in a parallel plate flow chamber. Hydrophobicity (by water contact angles), charge (by particulate microelectrophoresis) and elemental composition (by XPS) of the surfaces of seven bacterial strains were characterized, after which two strains were selected for further studies. On CL surfaces, hydrophobicity, elemental composition, and mean surface roughness (by AFM) were determined, as well as the protein composition of tear films adsorbed on these lenses (by sodium dodecylsulphate-polyacrylamide gel electrophoresis (SDS-PAGE)). Bacterial cell surfaces were relatively uncharged and water contact angles on lawns of different strains ranged from hydrophobic to hydrophilic. After adsorption of tear film components, N/C elemental surface concentrations increased on CL A and CL B and differences in water contact angles between both lenses reduced to range from 57 degrees (CL A) to 69 degrees (CL B). However, different protein compositions were inferred. The surface roughness of CL A increased from 4 to 13 nm. while it remained 16 nm for CL B. Adhesion of hydrophobic Pseudomonas aeruginosa #3 was more extensive than of hydrophilic Staphylococcus aureus 799, with no differences between both lenses. The hydrophobicity of P. aeruginosa #3 after cell surface damage decreased and its adhesion was reduced on CL A and strongly on CL B. In addition, passage of an air-liquid interface yielded more detachment of S. aureus 799 than of P. aeruginosa #3 from the CL surfaces. In conclusion, the hydrophobicity of CL surfaces dictates the composition of the adsorbed tear film and therewith plays an important role in bacterial adhesion to lenses. Adhesion of hydrophobic P. aeruginosa #3 was more tenacious than of hydrophilic S. aureus 799.

摘要

本文旨在通过平行平板流动腔,测定两种经物理化学特性表征的细菌菌株在有和没有吸附泪膜的情况下,对亲水性(CL A,水接触角57度)和疏水性(CL B,水接触角106度)水凝胶隐形眼镜(CL)表面的粘附情况。对七种细菌菌株表面的疏水性(通过水接触角)、电荷(通过颗粒微电泳)和元素组成(通过X射线光电子能谱)进行了表征,之后选择了两种菌株进行进一步研究。测定了CL表面的疏水性、元素组成和平均表面粗糙度(通过原子力显微镜),以及吸附在这些镜片上的泪膜的蛋白质组成(通过十二烷基硫酸钠-聚丙烯酰胺凝胶电泳(SDS-PAGE))。细菌细胞表面相对不带电,不同菌株菌苔上的水接触角范围从疏水性到亲水性。吸附泪膜成分后,CL A和CL B表面的N/C元素表面浓度增加,两种镜片之间的水接触角差异减小到57度(CL A)至69度(CL B)的范围。然而,推断出不同的蛋白质组成。CL A的表面粗糙度从4纳米增加到13纳米,而CL B保持在16纳米。疏水性铜绿假单胞菌#3的粘附比亲水性金黄色葡萄球菌799更广泛,两种镜片之间没有差异。铜绿假单胞菌#3细胞表面受损后的疏水性降低,其在CL A上的粘附减少,在CL B上则显著减少。此外,气液界面的通过使金黄色葡萄球菌799比铜绿假单胞菌#3从CL表面更多地脱离。总之,CL表面的疏水性决定了吸附泪膜的组成,从而在细菌对镜片的粘附中起重要作用。疏水性铜绿假单胞菌#3的粘附比亲水性金黄色葡萄球菌799更持久。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验