Mendes Robert R, Farber Mark A, Marston William A, Dinwiddie Lesley C, Keagy Blair A, Burnham Steven J
Department of Surgery, Division of Vascular Surgery, University of North Carolina at Chapel Hill School of Medicine, 27599-7212, USA.
J Vasc Surg. 2002 Sep;36(3):460-3. doi: 10.1067/mva.2002.126544.
The purpose of this study was to determine whether the preoperative minimal cephalic vein size in the forearm was predictive of successful wrist fistula maturation to a functional hemodialysis access.
Forty-four consecutive patients underwent evaluation before surgery with ultrasound scan imaging to map the entire cephalic vein in preparation for the construction of an arteriovenous fistula at the wrist. Measurements of the vein diameter were obtained from the ultrasound scan images at eight representative sites. Patients were clinically followed to determine maturation of the fistula to provide a functional hemodialysis access. The smallest diameter of the cephalic vein then was used as a preoperative predictor of fistula maturation.
Successful maturation of the arteriovenous fistula was achieved in 22 of the procedures (50%). Cephalic veins with a minimal diameter of 2.0 mm or less were used for anastamosis in 19 patients (43%), and three of these procedures (16%) led to a functional access site. The remaining 25 patients (57%) had minimal cephalic vein diameters greater than 2.0 mm, producing a successful maturation in 19 of the fistula creations (76%). A significantly higher rate of successful fistula maturation in those patients with a preoperative minimal cephalic vein size greater than 2.0 mm was realized (P =.0002, chi(2) test, with Yates correction for continuity).
In patients with a minimal cephalic vein size of 2.0 mm or less, a procedure other than wrist fistula should be considered for optimization of dialysis access.
本研究旨在确定前臂术前头静脉的最小尺寸是否可预测腕部动静脉内瘘能否成功成熟为功能性血液透析通路。
44例连续患者在手术前行超声扫描成像评估,以描绘整条头静脉,为腕部动静脉内瘘的构建做准备。从超声扫描图像的八个代表性部位获取静脉直径测量值。对患者进行临床随访,以确定内瘘是否成熟,从而提供功能性血液透析通路。然后将头静脉的最小直径用作内瘘成熟的术前预测指标。
22例手术(50%)实现了动静脉内瘘的成功成熟。19例患者(43%)使用最小直径为2.0mm或更小的头静脉进行吻合,其中3例手术(16%)形成了功能性通路部位。其余25例患者(57%)头静脉最小直径大于2.0mm,19例内瘘创建(76%)成功成熟。术前头静脉最小尺寸大于2.0mm的患者内瘘成功成熟率显著更高(P = 0.0002,卡方检验,采用耶茨连续性校正)。
对于头静脉最小尺寸为2.0mm或更小的患者,应考虑采用除腕部内瘘以外的其他手术来优化透析通路。