Ahmad Syed S, Walsh Peter N
The Sol Sherry Thrombosis Research Center and Department of Biochemistry, Temple University School of Medicine, Philadelphia, Pennsylvania 19140, USA.
Biochemistry. 2002 Sep 17;41(37):11269-76. doi: 10.1021/bi025785v.
The assembly of the factor X activating complex on the platelet surface requires the occupancy of three receptors: (1) enzyme factor IXa, (2) cofactor factor VIII(a), and (3) substrate factor X. To further evaluate this three-receptor model, simultaneous binding isotherms of (125)I-factor X and (131)I-factor VIII(a) to activated platelets were determined as a function of time and also as a function of the concentrations of both ligands in the presence of active site-inhibited factor IXa (45 nM) and 5 mM CaCl(2). In the presence of active site-inhibited factor IXa and factor VIIIa there are two independent factor X binding sites: (1) low affinity, high capacity (approximately 9000 sites/platelet; K(d) approximately 380 nM) and (2) low capacity, high affinity (1700 sites/platelet; K(d) approximately 30 nM). A single specific and selective factor X binding site was expressed (1200 sites/platelet; K(d) approximately 9 nM) when the shared factor X/factor II site was blocked by excess factor II (4 microM). In the presence of active site-inhibited factor IXa (4 nM) and factor II (4 microM), factor X binds to 3-fold more platelet sites than procofactor VIII with relatively low affinity (K(d) approximately 250 nM). The activation of procofactor VIII to factor VIIIa increases the affinity of binding to platelets of both factor VIIIa ( approximately 4-fold to K(d) approximately 0.8-1.5 nM) and factor X ( approximately 25-50-fold to K(d) approximately 5-9 nM). In the presence of excess zymogen factor IX, which blocks the shared factor IX/factor IXa binding site, the substrate, factor X, and the active cofactor, factor VIIIa, form a 1:1 stoichiometric complex. These coordinate binding studies support the conclusion that factor X initially binds to a high-capacity, low-affinity platelet binding site shared with prothrombin, which then presents factor X to a specific high-affinity site consisting of factor VIIIa bound to a high-affinity, low-capacity receptor on activated platelets.
凝血因子X激活复合物在血小板表面的组装需要占据三种受体:(1)酶促因子IXa,(2)辅因子因子VIII(a),以及(3)底物因子X。为了进一步评估这种三受体模型,测定了(125)I-因子X和(131)I-因子VIII(a)与活化血小板的同步结合等温线,作为时间的函数,以及在活性位点被抑制的因子IXa(45 nM)和5 mM氯化钙存在下两种配体浓度的函数。在活性位点被抑制的因子IXa和因子VIIIa存在的情况下,有两个独立的因子X结合位点:(1)低亲和力、高容量(约9000个位点/血小板;解离常数约380 nM),以及(2)低容量、高亲和力(1700个位点/血小板;解离常数约30 nM)。当共同的因子X/因子II位点被过量的因子II(4 microM)阻断时,表达了一个单一的特异性和选择性因子X结合位点(1200个位点/血小板;解离常数约9 nM)。在活性位点被抑制的因子IXa(4 nM)和因子II(4 microM)存在的情况下,因子X以相对较低的亲和力(解离常数约250 nM)与血小板位点的结合量是前辅因子VIII的3倍。前辅因子VIII激活为因子VIIIa增加了因子VIIIa(约4倍至解离常数约0.八至1.5 nM)和因子X(约25至50倍至解离常数约5至9 nM)与血小板结合的亲和力。在过量的酶原因子IX存在的情况下,它阻断了共同的因子IX/因子IXa结合位点,底物因子X和活性辅因子因子VIIIa形成1:1化学计量复合物。这些协同结合研究支持以下结论:因子X最初结合到与凝血酶原共享的高容量、低亲和力血小板结合位点,然后将因子X呈递给一个由结合到活化血小板上高亲和力、低容量受体的因子VIIIa组成的特异性高亲和力位点。