Suppr超能文献

低营养条件下饮用水中的大量水相和生物膜生长。

Bulk water phase and biofilm growth in drinking water at low nutrient conditions.

作者信息

Boe-Hansen Rasmus, Albrechtsen Hans-Jørgen, Arvin Erik, Jørgensen Claus

机构信息

Environment and Resources DTU, Technical University of Denmark, Lyngby.

出版信息

Water Res. 2002 Nov;36(18):4477-86. doi: 10.1016/s0043-1354(02)00191-4.

Abstract

In this study, the bacterial growth dynamics of a drinking water distribution system at low nutrient conditions was studied in order to determine bacterial growth rates by a range of methods, and to compare growth rates in the bulk water phase and the biofilm. A model distribution system was used to quantify the effect of retention times at hydraulic conditions similar to those in drinking water distribution networks. Water and pipe wall samples were taken and examined during the experiment. The pipes had been exposed to drinking water at approximately 13 degrees C, for at least 385 days to allow the formation of a mature quasi-stationary biofilm. At retention times of 12 h, total bacterial counts increased equivalent to a net bacterial growth rate of 0.048 day(-1). The bulk water phase bacteria exhibited a higher activity than the biofilm bacteria in terms of culturability, cell-specific ATP content, and cell-specific leucine incorporation rate. Bacteria in the bulk water phase incubated without the presence of biofilm exhibited a bacterial growth rate of 0.30 day(-1). The biofilm was radioactively labelled by the addition of 14C-benzoic acid. Subsequently, a biofilm detachment rate of 0.013 day(-1) was determined by measuring the release of 14C-labelled bacteria of the biofilm. For the quasi-stationary phase biofilm, the detachment rate was equivalent to the net growth rate. The growth rates determined in this study by different independent experimental approaches were comparable and within the range of values reported in the literature.

摘要

在本研究中,对低营养条件下饮用水分配系统中的细菌生长动态进行了研究,以便通过一系列方法确定细菌生长速率,并比较水体相和生物膜中的生长速率。使用一个模型分配系统来量化在与饮用水分配网络相似的水力条件下停留时间的影响。在实验过程中采集并检测了水样和管壁样本。这些管道已在约13摄氏度的饮用水中暴露至少385天,以使成熟的准稳态生物膜形成。在12小时的停留时间下,总细菌数增加,相当于净细菌生长速率为0.048天⁻¹。就可培养性、细胞特异性ATP含量和细胞特异性亮氨酸掺入率而言,水体相细菌比生物膜细菌表现出更高的活性。在没有生物膜存在的情况下培养的水体相细菌的生长速率为0.30天⁻¹。通过添加¹⁴C-苯甲酸对生物膜进行放射性标记。随后,通过测量生物膜中¹⁴C标记细菌的释放量,确定生物膜脱落速率为0.013天⁻¹。对于准稳态阶段的生物膜,脱落速率相当于净生长速率。本研究通过不同独立实验方法确定的生长速率具有可比性,且在文献报道的值范围内。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验