Suppr超能文献

非人灵长类动物经铒激光制备窝洞后的牙髓组织学——一项初步研究

Pulp histology after Er:YAG laser cavity preparation in subhuman primates--a pilot study.

作者信息

Louw N P, Pameijer C H, Ackermann W D, Ertl T, Cappius H J, Norval G

机构信息

University of Stellenbosch, Tygerberg, South Africa.

出版信息

SADJ. 2002 Aug;57(8):313-7.

Abstract

UNLABELLED

The aim of the study was to make a direct comparison of the pulpal effects of laser and turbine preparations in subhuman primates. One female baboon (Papio Ursinus ursinus), weighing 15 kg, was used. General anaesthesia was administered (ketamine 100 mg/ml/kg body weight) and maintained with acepromazine (10 mg/ml/kg body weight). Class V cavities were prepared buccally in a total of 28 teeth (7 in each quadrant). Teeth in the upper right and lower left quadrants were prepared using a conventional 330 carbide bur in a high-speed fibre-optic handpiece with copious water spray. Teeth in the upper left and lower right quadrants were prepared using an Er:YAG laser drill (Fotona Twinlight, Llubljana, Slovenia) delivering 500 mJ at a pulse rate of 10 Hz and a wavelength of 2940 nm. The animal was sacrificed after 25 days. After general anaesthesia as described before, perfusion fixation of the head was accomplished with 10% neutral buffered formalin, pumped through a catheter inserted into the left carotid artery. The jaws were removed and, using a 330 carbide bur in a high speed handpiece, a continuous groove was cut through the bone and the roots at the level of the middle third of all the roots to promote thorough fixation of pulpal tissue. Decalcification and grading of the severity of the pulpal responses were conducted according to standard procedures.

RESULTS

Owing to procedural errors seven teeth, FDI numbers 23, 24, 31, 34, 35, 44 and 45, had to be eliminated. The turbine-prepared teeth (N = 11) had a mean remaining dentine thickness (RDT) of 0.77 mm (SD = 0.42) and the laser-prepared teeth (N = 10) had a mean RDT of 0.81 mm (SD = 0.60). All pulps appeared normal except in one turbine-prepared tooth (12 with RDT = 0.20) and one laser-prepared tooth (27 with RDT = 0.30, where irreversible damage was caused. The only other deviations from normal were seen in the laser-treated 41 (RDT = 0.69) and the turbine-treated 36 (RDT = 0.77) where moderate hyperaemia was seen. Within the limitations of this study it can be concluded that there is no significant difference between dental pulp of teeth where Class V cavities were prepared with an Er:YAG laser drill compared with those prepared with a standard turbine drill.

摘要

未标注

本研究的目的是在非人灵长类动物中直接比较激光和涡轮机预备对牙髓的影响。使用了一只体重15千克的雌性狒狒(南非山魈)。给予全身麻醉(氯胺酮100毫克/毫升/千克体重),并用乙酰丙嗪(10毫克/毫升/千克体重)维持。在总共28颗牙齿(每个象限7颗)的颊侧制备V类洞。右上象限和左下象限的牙齿使用传统的330号硬质合金车针在高速光纤手机上并大量喷水进行预备。左上象限和右下象限的牙齿使用铒钇铝石榴石激光钻(Fotona Twinlight,斯洛文尼亚卢布尔雅那),以10赫兹的脉冲频率和2940纳米的波长发射500毫焦能量进行预备。25天后处死动物。按照之前所述给予全身麻醉后,通过插入左颈动脉的导管泵入10%中性缓冲福尔马林对头进行灌注固定。取下颌骨,使用高速手机上的330号硬质合金车针在所有牙根中三分之一水平处的骨和牙根上切割一条连续的沟,以促进牙髓组织的彻底固定。根据标准程序进行脱钙和牙髓反应严重程度分级。

结果

由于操作失误,7颗牙齿(FDI编号23、24、31、34、35、44和45)不得不被排除。涡轮机预备的牙齿(N = 11)平均剩余牙本质厚度(RDT)为0.77毫米(标准差 = 0.42),激光预备的牙齿(N = 10)平均RDT为0.81毫米(标准差 = 0.60)。除了一颗涡轮机预备的牙齿(12号,RDT = 0.20)和一颗激光预备的牙齿(27号,RDT = 0.30,造成了不可逆损伤)外,所有牙髓看起来都正常。唯一其他与正常情况的偏差见于激光治疗的41号牙齿(RDT = 0.69)和涡轮机治疗的36号牙齿(RDT = 0.77),可见中度充血。在本研究的局限性范围内,可以得出结论,与使用标准涡轮机钻制备V类洞的牙齿相比,使用铒钇铝石榴石激光钻制备V类洞的牙齿的牙髓之间没有显著差异。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验