Singsaas Eric L., Laporte Marianne M., Shi Jain-Zhong, Monson Russell K., Bowling David R., Johnson Kristine, Lerdau Manuel, Jasentuliytana Amal, Sharkey Thomas D.
Department of Botany, University of Wisconsin-Madison, 430 Lincoln Drive, Madison, WI 53706-1381, USA.
Tree Physiol. 1999 Dec;19(14):917-924. doi: 10.1093/treephys/19.14.917.
Because the rate of isoprene (2-methyl-1,3-butadiene) emission from plants is highly temperature-dependent, we investigated natural fluctuations in leaf temperature and effects of rapid temperature change on isoprene emission of red oak (Quercus rubra L.) leaves at the top of the canopy at Harvard Forest. Throughout the day, leaves often reached temperatures as much as 15 degrees C above air temperature. The highest temperatures were reached for only a few seconds at a time. We compared isoprene emission rates measured when leaf temperature was changed rapidly with those measured when temperature was changed slowly. In all cases, isoprene emission rate increased with increasing leaf temperature up to about 32 degrees C and then decreased with higher temperatures. The temperature at which isoprene emission rates began to decrease depended on how quickly measurements were made. Isoprene emission rates peaked at 32.5 degrees C when measured hourly, whereas rates peaked at 39 degrees C when measurements were made every four minutes. This behavior reflected the rapid increase in isoprene emission rate that occurred immediately after an increase in leaf temperature, and the subsequent decrease in isoprene emission rate when leaf temperature was held steady for longer than 20 minutes. We concluded that the observed temperature response of isoprene emission rate is a function of measurement protocol. Omitting this parameter from isoprene emission models will not affect simulated isoprene emission rates at mild temperatures, but can increase isoprene emission rates at high temperatures.
由于植物中异戊二烯(2-甲基-1,3-丁二烯)的排放速率高度依赖于温度,我们研究了哈佛森林树冠顶部红橡树(Quercus rubra L.)叶片温度的自然波动以及快速温度变化对异戊二烯排放的影响。一整天中,叶片温度常常比气温高出多达15摄氏度。最高温度每次仅持续几秒钟。我们比较了叶片温度快速变化时测得的异戊二烯排放速率与温度缓慢变化时测得的排放速率。在所有情况下,异戊二烯排放速率随叶片温度升高至约32摄氏度而增加,然后随着温度进一步升高而降低。异戊二烯排放速率开始下降的温度取决于测量的速度。每小时测量时,异戊二烯排放速率在32.5摄氏度时达到峰值,而每四分钟测量一次时,速率在39摄氏度时达到峰值。这种行为反映了叶片温度升高后异戊二烯排放速率立即快速增加,以及叶片温度保持稳定超过20分钟后异戊二烯排放速率随后下降的情况。我们得出结论,观察到的异戊二烯排放速率的温度响应是测量方案的函数。在异戊二烯排放模型中忽略此参数不会影响温和温度下模拟的异戊二烯排放速率,但会增加高温下的异戊二烯排放速率。