Cull Grant, Cioffi George A, Dong Jin, Homer Louis, Wang Lin
Discoveries in Sight, Devers Eye Institute, Portland, OR, USA.
J Glaucoma. 2003 Aug;12(4):301-6. doi: 10.1097/00061198-200308000-00003.
The goal of the present study is to develop a semi-automated method to estimate accurately, with minimum variance, the total number of axons by counting a subset of the axons within a primate optic nerve.
Using an imaging analysis system, axons in 50% of the area of cross-sections of the retrobulbar optic nerve from five adult Rhesus monkeys were counted and extrapolated as an estimate of total axon number of the optic nerves. Both neural and non-neural areas were sampled. With the coordinates of the counts topographically registered, axon numbers within areas ranging from 1 to 50% were resampled. A Monte Carlo and theoretical estimate of the standard deviation of the total axon count for each sampled area was computed.
The mean cross-sectional area of the five optic nerves counted was 7.26 +/- 0.6 mm2, and the mean total axon count of the optic nerve area was 1,304,8168 +/- 89,112. When sampling less than 8% of the optic nerve, the standard deviation within the individual of the total estimated axon number increased sharply.
With this technique, the variance within each individual increased only slightly when the counting area was reduced from 50 to 8%, but increased sharply when the counted area became less than 8%. While counting less than 8% of the optic nerve area gives a good estimation of total axon count, the effect of a substantial increase in the standard deviation on the statistical power needed to differentiate group differences will depend on the study design.
本研究的目标是开发一种半自动方法,通过对灵长类动物视神经内的一部分轴突进行计数,以最小的方差准确估计轴突总数。
使用成像分析系统,对5只成年恒河猴球后视神经横截面积50%区域内的轴突进行计数,并外推以估计视神经的轴突总数。同时对神经和非神经区域进行采样。根据计数的坐标进行地形配准,对1%至50%区域内的轴突数量进行重新采样。计算每个采样区域总轴突计数的蒙特卡罗和理论标准差估计值。
所计数的5条视神经的平均横截面积为7.26±0.6平方毫米,视神经区域的平均总轴突计数为1,304,8168±89,112。当对视神经采样少于8%时,个体内总估计轴突数的标准差急剧增加。
使用该技术,当计数区域从50%减少到8%时,每个个体内的方差仅略有增加,但当计数区域小于8%时则急剧增加。虽然对视神经区域计数少于8%能很好地估计总轴突数,但标准差大幅增加对区分组间差异所需统计功效的影响将取决于研究设计。