Johnson K A, Taylor E W
Biochemistry. 1978 Aug 22;17(17):3432-42. doi: 10.1021/bi00610a002.
The kinetics of the increase in protein fluorescence following the addition of ATP to subfragment-1 (SF-1) and acto-SF-1 have been reinvestigated. The concentration dependence of the rate obtained with SF-1 did not fit a hyperbola and at high ATP concentration, approximately 40% of the signal amplitude was lost due to a fast phase at the beginning of the transient (20 degrees C). At lower temperature (less than or equal to 10 degrees C) the fluorescence transient was biphasic, with a fast phase observed at high ATP concentration. These results indicate that there are two steps in the SF-1 pathway in which there is a change in protein fluorescence. Measurements of ATP binding and hydrolysis by chemical quench-flow methods indicate that the rate of ATP binding is correlated with the fast fluorescence step and hydrolysis is correlated with the slow fluorescence change. The SF-1 mechanism can thus be described as: (formula: see text) where M represents SF-1 and states of enhanced fluorescence are given by M (16%) and M (36% enhancement, relative to SF-1). Step 1 is a rapid equilibrium with K1 approximately 10(3) M-1. Tight binding of ATP occurs in step 2 and the loss of signal amplitude requires k2 greater than or approximately 1500--2000 s-1. The maximum observed fluorescence rate defines the rate of hydrolysis, k3 + k-3 = 125 s-1 (20 degrees C, 0.1 M KCl, pH 7.0). The steps in the mechanism correspond to the Bagshaw--Trentham scheme, with the important difference that the assignment of rate constant is altered. Formation of the acto-SF-1 complex gave a fluorescence enhancement of approximately 14% relative to SF-1. Dissociation of acto-SF-1 by ATP produced a 20--22% enhancement in fluorescence. There was no detectable fluorescence change during dissociation as evidenced by a lag in the fluorescence transient which corresponded to the kinetics of dissociation. The fluorescence change occurred at the same maximum rate as for SF-1 but there was no loss in signal amplitude at high ATP concentration. The kinetics of the fluorescence change corresponded to the rate of ATP hydrolysis, whereas tight ATP binding occurred at a much faster rate in approximate agreement with the rate of dissociation. Thus the fluorescence change in the acto-SF-1 pathway corresponds to step 3 in the SF-1 mechanism. The complete scheme can be described as follows: (formula: see text) where AM represents acto-SF-1. The tight binding step in the SF-1 pathway (k2) is sufficiently fast so that a similar step (k2') in the acto-SF-1 pathway could precede dissociation but the AM-ATP intermediate has not been detected. Following hydrolysis on the free SF-1, actin recombines with M.ADP.Pi or possibly with a second SF-1 product intermediate as proposed by Chock et al. (1976) and the fluorescence returns to the original AM level with product release.
在向亚片段 -1(SF -1)和肌动蛋白 -SF -1添加ATP后,蛋白质荧光增加的动力学已被重新研究。用SF -1获得的速率对浓度的依赖性不符合双曲线,并且在高ATP浓度下,由于瞬态开始时的快速相(20℃),约40%的信号幅度损失。在较低温度(小于或等于10℃)下,荧光瞬态是双相的,在高ATP浓度下观察到快速相。这些结果表明,在SF -1途径中有两个步骤会发生蛋白质荧光变化。通过化学淬灭 -流动法测量ATP结合和水解表明,ATP结合速率与快速荧光步骤相关,水解与缓慢荧光变化相关。因此,SF -1机制可描述为:(公式:见正文)其中M代表SF -1,荧光增强状态由M(16%)和M(相对于SF -1增强36%)给出。步骤1是一个快速平衡,K1约为10³ M⁻¹。ATP的紧密结合发生在步骤2中,信号幅度的损失要求k2大于或约为1500 - 2000 s⁻¹。观察到的最大荧光速率定义了水解速率,k3 + k⁻3 = 125 s⁻¹(20℃,0.1 M KCl,pH 7.0)。该机制中的步骤与Bagshaw - Trentham方案相对应,重要的区别在于速率常数的分配有所改变。肌动蛋白 -SF -1复合物的形成相对于SF -1产生了约14%的荧光增强。ATP使肌动蛋白 -SF -1解离产生了20 - 22%的荧光增强。解离过程中没有可检测到的荧光变化,荧光瞬态中的滞后证明了这一点,该滞后与解离动力学相对应。荧光变化以与SF -1相同的最大速率发生,但在高ATP浓度下信号幅度没有损失。荧光变化的动力学与ATP水解速率相对应,而紧密的ATP结合以更快的速率发生,大致与解离速率一致。因此,肌动蛋白 -SF -1途径中的荧光变化对应于SF -1机制中的步骤3。完整的方案可描述如下:(公式:见正文)其中AM代表肌动蛋白 -SF -1。SF -1途径中的紧密结合步骤(k2)足够快,以至于肌动蛋白 -SF -1途径中类似的步骤(k2')可能在解离之前发生,但尚未检测到AM -ATP中间体。在游离的SF -1上发生水解后,肌动蛋白与M.ADP.Pi重新结合,或者可能与Chock等人(1976年)提出的第二种SF -1产物中间体重新结合,并且随着产物释放,荧光恢复到原始的AM水平。