Suppr超能文献

过热对体外成熟的人类卵母细胞中的减数分裂纺锤体有害。

Overheating is detrimental to meiotic spindles within in vitro matured human oocytes.

作者信息

Sun Xiao-Fang, Wang Wei-Hua, Keefe David L

机构信息

Guang-Zhou Second Hospital, Gung-Dong, China.

出版信息

Zygote. 2004 Feb;12(1):65-70. doi: 10.1017/s0967199404002631.

Abstract

The present study was designed to examine the effects of overheating on meiotic spindle morphology within in vitro matured human oocytes using a polarized light microscope (Polscope). Immature human oocytes at either germinal vesicle or metaphase I stage were cultured in vitro for 24-36 h until they reached metaphase II (M-II) stage. After maturation, oocytes at M-II stage were imaged in the living state with the Polscope at 37, 38, 39 and 40 degrees C for up to 20 min. After heating, oocytes were returned to 37 degrees C and then imaged for another 20 min at 37 degrees C. The microtubules in the spindles were quantified by their maximum retardance, which represents the amount of microtubules. Spindles were intact at 37 degrees C during 40 min of examination and their maximum retardance (1.72-1.79) did not change significantly during imaging. More microtubules were formed in the spindles heated to 38 degrees C and the maximum retardance was increased from 1.77 before heating to 1.95 at 20 min after heating. By contrast, spindles started to disassemble when the temperature was increased to 39 degrees C for 10 min (maximum retardance was reduced from 1.76 to 1.65) or 40 degrees C for 1 min (maximum retardance was reduced from 1.75 to 1.5). At the end of heating (20 min), fewer microtubules were present in the spindles and the maximum retardance was reduced to 0.8 and 0.78 in the oocytes heated to 39 degrees C and 40 degrees C, respectively. Heating to 40 degrees C also induced spindles to relocate in the cytoplasm in some oocytes. After the temperature was returned to 37 degrees C, microtubules were repolymerized to form spindles, but the spindles were not reconstituted completely compared with the spindles imaged before heating. These results indicate that spindles in human eggs are sensitive to high temperature. Moreover, maintenance of an in vitro manipulation temperature of 37 degrees C is crucial for normal spindle morphology.

摘要

本研究旨在使用偏光显微镜(Polscope)检测过热对体外成熟的人类卵母细胞减数分裂纺锤体形态的影响。将处于生发泡期或中期I期的未成熟人类卵母细胞在体外培养24 - 36小时,直至它们达到中期II(M-II)期。成熟后,将处于M-II期的卵母细胞在37、38、39和40摄氏度下用Polscope进行活体成像,最长可达20分钟。加热后,将卵母细胞放回37摄氏度,然后在37摄氏度下再成像20分钟。纺锤体中的微管通过其最大延迟进行定量,最大延迟代表微管的数量。在37摄氏度下检查40分钟期间,纺锤体保持完整,并且在成像过程中其最大延迟(1.72 - 1.79)没有显著变化。加热到38摄氏度的纺锤体中形成了更多微管,最大延迟从加热前的1.77增加到加热后20分钟时的1.95。相比之下,当温度升至39摄氏度持续10分钟(最大延迟从1.76降至1.65)或40摄氏度持续1分钟(最大延迟从1.75降至1.5)时,纺锤体开始解体。在加热结束时(20分钟),加热到39摄氏度和40摄氏度的卵母细胞纺锤体中的微管数量减少,最大延迟分别降至0.8和0.78。加热到40摄氏度还导致一些卵母细胞中的纺锤体在细胞质中重新定位。温度恢复到37摄氏度后,微管重新聚合形成纺锤体,但与加热前成像的纺锤体相比,纺锤体没有完全重新形成。这些结果表明,人类卵子中的纺锤体对高温敏感。此外,将体外操作温度维持在37摄氏度对于正常的纺锤体形态至关重要。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验