Suppr超能文献

来自有限数据集的超高分辨率3D核磁共振谱。

Ultra-high resolution 3D NMR spectra from limited-size data sets.

作者信息

Chen Jianhan, Nietlispach Daniel, Shaka A J, Mandelshtam Vladimir A

机构信息

Chemistry Department, University of California, Irvine, CA 92697, USA.

出版信息

J Magn Reson. 2004 Aug;169(2):215-24. doi: 10.1016/j.jmr.2004.04.017.

Abstract

The advantage of the filter diagonalization method (FDM) for analysis of triple-resonance NMR experiments is demonstrated by application to a 3D constant time (CT) HNCO experiment. With a 15N-,13C-labeled human ubiquitin sample (1.0 mM), high spectral resolution was obtained at 500 MHz in 25 min with only 6-8 increments in each of the CT dimensions. This data set size is about a factor of 50-100 smaller than typically required, yet FDM analysis results in a fully resolved spectrum with a sharp peak for each HNCO resonance. Unlike Fourier transform (FT) processing, in which spectral resolution in each dimension is inversely proportional to the acquisition time in this dimension, FDM is a true multi-dimensional method; the resolution in all dimensions is determined by the total information content of the entire signal. As the CT dimensions of the 3D HNCO signal have approximate time-reversal symmetry, they can each be doubled by combining the usual four hyper-complex data sets. This apparent quadrupling of the data is important to the success of the method. Thus, whenever raw sensitivity is not limiting, well-resolved n-dimensional spectra can now be obtained in a small fraction of the usual time. Alternatively, to maximize sensitivity, evolution periods of faster relaxing nuclei may be radically shortened, the total required resolution being obtained through chemical shift encoding of other, more slowly relaxing, spins. Improvements similar to those illustrated with a 3D HNCO spectrum are expected for other triple-resonance spectra, where CT evolution in the indirect dimensions is implemented.

摘要

通过将滤波对角化方法(FDM)应用于三维恒时(CT)HNCO实验,证明了该方法在分析三共振核磁共振实验中的优势。使用15N、13C标记的人泛素样品(1.0 mM),在500 MHz下,每个CT维度仅需6 - 8次增量,25分钟内即可获得高光谱分辨率。该数据集大小比通常所需的小约50 - 100倍,但FDM分析得到的是一个完全解析的光谱,每个HNCO共振都有一个尖锐的峰。与傅里叶变换(FT)处理不同,在FT处理中每个维度的光谱分辨率与该维度的采集时间成反比,FDM是一种真正的多维方法;所有维度的分辨率由整个信号的总信息含量决定。由于三维HNCO信号的CT维度具有近似的时间反转对称性,通过组合通常的四个超复数数据集,每个维度都可以加倍。这种数据的明显四倍增加对该方法的成功至关重要。因此,只要原始灵敏度不是限制因素,现在就可以在通常时间的一小部分内获得分辨率良好的n维光谱。或者,为了最大化灵敏度,可以大幅缩短快速弛豫核的演化时间,通过对其他弛豫较慢的自旋进行化学位移编码来获得所需的总分辨率。对于其他在间接维度中实现CT演化的三共振光谱,预计会有类似于用三维HNCO光谱说明的改进。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验