Ly Hung V, Longo Marjorie L
Department of Chemical Engineering and Material Science, University of California, Davis, California, USA.
Biophys J. 2004 Aug;87(2):1013-33. doi: 10.1529/biophysj.103.034280.
We used micropipette aspiration to directly measure the area compressibility modulus, bending modulus, lysis tension, lysis strain, and area expansion of fluid phase 1-stearoyl, 2-oleoyl phosphatidylcholine (SOPC) lipid bilayers exposed to aqueous solutions of short-chain alcohols at alcohol concentrations ranging from 0.1 to 9.8 M. The order of effectiveness in decreasing mechanical properties and increasing area per molecule was butanol>propanol>ethanol>methanol, although the lysis strain was invariant to alcohol chain-length. Quantitatively, the trend in area compressibility modulus follows Traube's rule of interfacial tension reduction, i.e., for each additional alcohol CH(2) group, the concentration required to reach the same area compressibility modulus was reduced roughly by a factor of 3. We convert our area compressibility data into interfacial tension values to: confirm that Traube's rule is followed for bilayers; show that alcohols decrease the interfacial tension of bilayer-water interfaces less effectively than oil-water interfaces; determine the partition coefficients and standard Gibbs adsorption energy per CH(2) group for adsorption of alcohol into the lipid headgroup region; and predict the increase in area per headgroup as well as the critical radius and line tension of a membrane pore for each concentration and chain-length of alcohol. The area expansion predictions were confirmed by direct measurements of the area expansion of vesicles exposed to flowing alcohol solutions. These measurements were fitted to a membrane kinetic model to find membrane permeability coefficients of short-chain alcohols. Taken together, the evidence presented here supports a view that alcohol partitioning into the bilayer headgroup region, with enhanced partitioning as the chain-length of the alcohol increases, results in chain-length-dependent interfacial tension reduction with concomitant chain-length-dependent reduction in mechanical moduli and membrane thickness.
我们使用微量移液器抽吸法直接测量了暴露于浓度范围为0.1至9.8 M的短链醇水溶液中的1-硬脂酰基-2-油酰基磷脂酰胆碱(SOPC)脂质双层的面积压缩模量、弯曲模量、裂解张力、裂解应变和面积膨胀。尽管裂解应变与醇链长度无关,但在降低机械性能和增加每分子面积方面的有效性顺序为丁醇>丙醇>乙醇>甲醇。定量地说,面积压缩模量的趋势遵循特劳贝界面张力降低规则,即对于每增加一个醇的CH(2)基团,达到相同面积压缩模量所需的浓度大致降低3倍。我们将面积压缩数据转换为界面张力值,以确认双层遵循特劳贝规则;表明醇降低双层-水界面的界面张力的效果不如油-水界面;确定醇吸附到脂质头基团区域的分配系数和每个CH(2)基团的标准吉布斯吸附能;并预测每种醇浓度和链长度下每个头基团面积的增加以及膜孔的临界半径和线张力。通过直接测量暴露于流动醇溶液的囊泡的面积膨胀来证实面积膨胀预测。这些测量结果拟合到一个膜动力学模型中,以找到短链醇的膜渗透系数。综上所述,此处提供的证据支持这样一种观点,即醇分配到双层头基团区域,随着醇链长度的增加分配增强,导致链长度依赖性的界面张力降低,同时伴随着链长度依赖性的机械模量和膜厚度降低。