Schmalenberg Kristine E, Uhrich Kathryn E
Department of Chemistry and Chemical Biology, Rutgers University, 610 Taylor Road, Piscataway, NJ 08854, USA.
Biomaterials. 2005 Apr;26(12):1423-30. doi: 10.1016/j.biomaterials.2004.04.046.
Microcontact printed polymeric substrates were evaluated for their ability to control Schwann cell attachment and direct proliferation, as Schwann cell guidance is a crucial factor in directing peripheral nerve regeneration. Elastomeric stamps of poly(dimethylsiloxane) were "inked" with laminin, a permissive protein for Schwann cell adhesion, and stamped onto poly(methyl methacrylate) substrates to create patterns of lines and intervals varying from 10 to 50 microm wide. Schwann cells were seeded onto the substrates in serum-free media. After 4h, media was replaced with serum-containing growth media and changed daily thereafter. The addition of growth media to stimulate proliferation initially caused some loss in cell orientation relative to the laminin pattern, but when monolayer formation was complete, a high degree of cell orientation was observed. As both cell-cell contacts and surface coverage were maximized, the Schwann cells achieved an even higher order of orientation than observed during the early stages of proliferation. Significantly, smaller pattern widths increased the degree of orientation, regardless of interval width. Our results indicate that patterned polymeric substrates may enhance peripheral nerve regeneration by creating a highly ordered Schwann cell matrix for guidance of neurons.
微接触印刷聚合物基质被评估其控制雪旺细胞附着和直接增殖的能力,因为雪旺细胞引导是指导周围神经再生的关键因素。聚二甲基硅氧烷的弹性印章用层粘连蛋白“蘸墨”,层粘连蛋白是一种促进雪旺细胞黏附的蛋白质,然后将其印在聚甲基丙烯酸甲酯基质上,以形成宽度从10到50微米不等的线条和间隔图案。将雪旺细胞接种到无血清培养基中的基质上。4小时后,将培养基换成含血清的生长培养基,此后每天更换。添加生长培养基以刺激增殖最初会导致细胞相对于层粘连蛋白图案的取向出现一些损失,但当单层形成完成时,观察到高度的细胞取向。由于细胞间接触和表面覆盖都达到了最大化,雪旺细胞实现了比增殖早期观察到的更高程度的取向。值得注意的是,无论间隔宽度如何,较小的图案宽度都会增加取向程度。我们的结果表明,图案化聚合物基质可以通过创建高度有序的雪旺细胞基质来引导神经元,从而增强周围神经再生。