Yun Z, Lee H, Choi E
Department of Environmental Engineering, Korea University, Jochiwon, Choong Nam 339-800, Korea.
Water Sci Technol. 2004;50(10):121-30.
The rotating biological contactor (RBC) system was operationally modified with a sequencing batch reactor to achieve biological phosphorus removal from a weak domestic sewage along with nitrogen removal. This study utilized three RBC units, of which two units were the main units to remove phosphorus and NH4N and the third RBC unit was used as the storage of wastewater for its minimal effect to the PAO activities in the anaerobic stage during the operation. It was noticed that the biofilm thickness in RBC must be controlled to be less than 1.8 mm in order to achieve more than 70% of P removal with about 60% of N removal. With a settled sewage representing 200 mg/L of COD and 5 mg/L of P, the predicted P content in biofilm was more than 3% and the effluent P concentration was about 1 mg/L. The %P content in biofilm decreased with an increase of influent COD/TP ratios. The COD requirement for anaerobic P release was similar to reported values for the suspended growth system, however, the overall requirement increased with thicker biofilm.
旋转生物接触器(RBC)系统通过序批式反应器进行操作改造,以实现从低强度生活污水中同时去除生物磷和氮。本研究使用了三个RBC单元,其中两个单元是去除磷和NH4N的主要单元,第三个RBC单元用作废水储存单元,因为其在运行过程中对厌氧阶段聚磷菌(PAO)活性的影响最小。研究发现,为了实现70%以上的磷去除率和约60%的氮去除率,必须将RBC中的生物膜厚度控制在1.8毫米以下。对于含有200 mg/L化学需氧量(COD)和5 mg/L磷的沉淀污水,生物膜中的预测磷含量超过3%,出水磷浓度约为1 mg/L。生物膜中的磷含量百分比随着进水COD/总磷(TP)比值的增加而降低。厌氧释磷所需的COD与悬浮生长系统的报道值相似,然而,随着生物膜变厚,总体需求量增加。