Weng Lihui, Zhang Lina, Ruan Dong, Shi Lianghe, Xu Jian
Department of Chemistry, Wuhan University, Wuhan 430072, People's Republic of China.
Langmuir. 2004 Mar 16;20(6):2086-93. doi: 10.1021/la035995o.
Utilizing a novel solvent of cellulose, 6 wt % NaOH/5 wt % thiourea aqueous solution, for the first time, we prepared the thermally induced cellulose gel. We investigated the thermal gelation of cellulose solutions with rheometry and the structure of the gel with 13C NMR, wide-angle X-ray diffraction, environmental scanning electron microscopy, and atomic force microscopy. The cellulose solutions revealed an increase in both the storage modulus (G') and the loss modulus (G") with an increase in the temperature during gelation. The temperature at the turning point, where G' overrides G" because of the onset of gelation, decreased from 38.6 to 20.1 degrees C with an increase of cellulose concentration from 4 to 6 wt %. Given enough time, G' of all solutions can exceed G" at a certain temperature slightly lower than the gelation temperature, indicating that the occurrence of the gelation is also a function of time. Each of the assigned peaks of NMR of the cellulose gel is similar to that of the cellulose solution, suggesting that the gelation resulted from a physical cross-linking. The gels were composed of relatively stable network units with an average diameter of about 47 nm. At either a higher temperature (at 60 degrees C for 30 s) or a longer gelation time (at 30 degrees C for 157 s), the gel in the 5 wt % cellulose solution could form. A schematic gelation process was proposed to illustrate the sol-gel transition: the random self-association of the cellulose chains having the exposed hydroxyl in the aqueous solution promotes the physical cross-linking networks.
首次使用一种新型纤维素溶剂——6 wt%氢氧化钠/5 wt%硫脲水溶液,我们制备了热致纤维素凝胶。我们用流变学研究了纤维素溶液的热凝胶化过程,并用13C核磁共振、广角X射线衍射、环境扫描电子显微镜和原子力显微镜研究了凝胶的结构。纤维素溶液在凝胶化过程中,随着温度升高,储能模量(G')和损耗模量(G")均增加。由于凝胶化开始,G'超过G"的转折点温度,随着纤维素浓度从4 wt%增加到6 wt%,从38.6℃降至20.1℃。在足够长的时间内,所有溶液的G'在略低于凝胶化温度的某一温度下都能超过G",这表明凝胶化的发生也是时间的函数。纤维素凝胶核磁共振的每个归属峰与纤维素溶液的相似,表明凝胶化是由物理交联引起的。凝胶由平均直径约为47 nm的相对稳定的网络单元组成。在较高温度(60℃下30 s)或较长凝胶化时间(30℃下157 s)下,5 wt%纤维素溶液中的凝胶都能形成。提出了一个示意性的凝胶化过程来说明溶胶-凝胶转变:在水溶液中具有暴露羟基的纤维素链的随机自缔合促进了物理交联网络。