Sekhon Lali H S
Department of Neurosurgery and Spinal Injuries Unit, Royal North Shore Hospital and University of Sydney, Sydney, N.S.W., Australia.
J Spinal Disord Tech. 2005 Aug;18(4):297-303. doi: 10.1097/01.bsd.0000166640.23448.09.
This study evaluates the results and complications of 1026 consecutive lateral mass screws inserted in 143 patients by a single surgeon.
Over a 50-month period, a total of 1026 lateral mass screws were placed in 143 patients ages 12-96 years (56 females and 87 males), with these records retrospectively reviewed. Screw position was evaluated by computed tomography (CT) scanning postoperatively, with screw positions assessed for facet, foraminal, or foramen transversarium violation.
All screws were placed by a modification of the Anderson technique, but 20 screws were converted to Roy-Camille trajectories because of screw pullout. No patients experienced neural injury or vertebral artery injury as a result of screw placement. Three patients had screw pullouts using the Axis system, which did not require reoperation. Most patients had 14-mm screws placed. Postoperative CT scanning showed no compromise of the foramen transversarium or neural foramen. A total of 94 C7 lateral mass screws were placed without the need for pedicle screws at this level. Forty-four cases were performed with a screw/plate construct with the remainder performed using a polyaxial screw/rod construct. One patient had a symptomatic adjacent-level disc herniation that required surgical intervention. One patient required extension of laminectomy for residual compression.
Lateral mass screw fixation is a safe and effective stabilization technique. This study demonstrates the safety and efficacy of lateral mass cannulation for a range of cervical pathologies with the largest reported series of consecutive lateral mass screws in the literature. In most cases of subaxial disease, nonconstrained plate/screw systems provide a reasonable alternative to polyaxial screw/rod constructs. Most patients can be fixated with 14-mm length x 3.5-mm diameter screws. The C7 lateral mass can be drilled with an adjusted trajectory.
本研究评估由一名外科医生为143例患者连续植入1026枚侧块螺钉的结果及并发症。
在50个月的时间里,共为12至96岁的143例患者(56例女性和87例男性)植入1026枚侧块螺钉,并对这些记录进行回顾性分析。术后通过计算机断层扫描(CT)评估螺钉位置,评估螺钉位置是否侵犯关节突、椎间孔或横突孔。
所有螺钉均采用改良的安德森技术植入,但由于螺钉拔出,20枚螺钉改为罗伊 - 卡米尔入路。没有患者因螺钉植入而出现神经损伤或椎动脉损伤。3例患者使用Axis系统出现螺钉拔出,无需再次手术。大多数患者植入的是14毫米的螺钉。术后CT扫描显示横突孔或神经孔未受影响。共植入94枚C7侧块螺钉,此节段无需椎弓根螺钉。44例采用螺钉/钢板结构,其余采用多轴螺钉/棒结构。1例患者出现有症状的相邻节段椎间盘突出,需要手术干预。1例患者因残留压迫需要扩大椎板切除术。
侧块螺钉固定是一种安全有效的稳定技术。本研究证明了侧块置钉对于一系列颈椎病变的安全性和有效性,是文献中报道的连续侧块螺钉数量最多的系列。在大多数下颈椎疾病病例中,非限制性钢板/螺钉系统为多轴螺钉/棒结构提供了合理的替代方案。大多数患者可用14毫米长×3.5毫米直径的螺钉固定。C7侧块可采用调整后的入路进行钻孔。