Ikeda Kazuyuki, Okazaki Yukio, Furukawa Kojirou, Ohtsubo Satoshi, Yunoki Junji, Natsuaki Masafumi, Itoh Tsuyoshi
Department of Thoracic and Cardiovascular Surgery, Saga University Faculty of Medicine, 5-1-1 Nabeshima, Saga 849-8501, Japan.
Eur J Cardiothorac Surg. 2006 Jun;29(6):1014-9. doi: 10.1016/j.ejcts.2006.02.052. Epub 2006 May 3.
The optimal orientation of a bileaflet mechanical valve for tricuspid valve replacement (TVR) has not yet been determined. The aim of this study was to use fiberoptic cardioscopy to evaluate the effect of orientation of a mechanical valve implanted in the tricuspid position on bileaflet mechanical valve behavior.
Twelve pigs (50-59 kg) underwent TVR with a St. Jude Mechanical Heart Valve (25 mm standard cuff model) after cardioplegic arrest. The mechanical valve was implanted horizontally in six pigs (Group H), and vertically in another six pigs (Group V). The heart was perfused with pellucid Krebs-Henseleit solution in situ and the mechanical valve behavior was observed with a fiberoptic endoscope during different heart rates (HRs) induced by ventricular pacing (60, 90, 120, 150 min(-1)). All images were recorded on a high-speed video system every 4 ms. The closing time lag (CTL) between the valve leaflets was calculated and compared between the two groups.
In Group H, the lower valve leaflet tended to open incompletely and close earlier than the upper leaflet. The calculated CTL was 303+/-60 ms, 65+/-48 ms, 40+/-9 ms, and 40+/-26 ms at pacing HRs of 60, 90, 120, and 150 min(-1), respectively. In contrast to Group H, there was little difference in CTL between the right and left leaflets in Group V. The calculated CTL was 9+/-12 ms, 11+/-10 ms, 1+/-3 ms, and 6+/-7 ms at pacing HRs of 60, 90, 120, and 150 min(-1), respectively. There were significant differences in CLT between the two groups at each ventricular pacing rate (P < 0.01).
Orientation of an implanted bileaflet valve in the tricuspid position significantly influenced leaflet motion. In a horizontal orientation, the lower valve leaflet opened incompletely and closed earlier than the upper leaflet. These results suggest that the gravity might affect leaflet motion and that bileaflet mechanical valves should be implanted vertically in TVR to prevent abnormal leaflet motion and thrombus formation.
双叶机械瓣膜用于三尖瓣置换术(TVR)的最佳方向尚未确定。本研究的目的是使用光纤心脏镜评估植入三尖瓣位置的机械瓣膜方向对双叶机械瓣膜行为的影响。
12头猪(体重50 - 59千克)在心脏停搏后接受了使用圣犹达机械心脏瓣膜(25毫米标准袖套型号)的TVR。机械瓣膜在6头猪中水平植入(H组),在另外6头猪中垂直植入(V组)。心脏在原位用透明的克雷布斯 - 亨塞尔特溶液灌注,并在心室起搏诱导的不同心率(HRs)(60、90、120、150次/分钟)期间用光纤内窥镜观察机械瓣膜行为。所有图像每4毫秒记录在高速视频系统上。计算瓣膜小叶之间的关闭时间延迟(CTL)并在两组之间进行比较。
在H组中,下部瓣膜小叶倾向于不完全打开且比上部小叶更早关闭。在起搏心率为60、90、120和150次/分钟时,计算出的CTL分别为303±60毫秒、65±48毫秒、40±9毫秒和40±26毫秒。与H组相反,V组左右小叶之间的CTL差异很小。在起搏心率为60、90、120和150次/分钟时,计算出的CTL分别为9±12毫秒、11±10毫秒、1±3毫秒和6±7毫秒。在每个心室起搏率下,两组之间的CLT存在显著差异(P < 0.01)。
植入三尖瓣位置的双叶瓣膜方向显著影响小叶运动。在水平方向上,下部瓣膜小叶不完全打开且比上部小叶更早关闭。这些结果表明重力可能影响小叶运动,并且双叶机械瓣膜在TVR中应垂直植入以防止小叶异常运动和血栓形成。