David Jean R, Legout Hélène, Moreteau Brigitte
CNRS, Laboratoire Populations, Génétique et Evolution, 91198 Gif-sur-Yvette cedex, France.
J Genet. 2006 Apr;85(1):9-23. doi: 10.1007/BF02728965.
A natural population of Drosophila melanogaster in southern France was sampled in three different years and 10 isofemale lines were investigated from each sample. Two size-related traits, wing and thorax length, were measured and the wing/thorax ratio was also calculated. Phenotypic plasticity was analysed after development at seven different constant temperatures, ranging from 12 degrees C to 31 degrees C. The three year samples exhibited similar reaction norms, suggesting a stable genetic architecture in the natural population. The whole sample (30 lines) was used to determine precisely the shape of each reaction norm, using a derivative analysis. The practical conclusion was that polynomial adjustments could be used in all cases, but with different degrees: linear for the wing/thorax ratio, quadratic for thorax length, and cubic for wing length. Both wing and thorax length exhibited concave reaction norms, with a maximum within the viable thermal range. The temperatures of the maxima were, however, quite different, around 15 degrees C for the wing and 19.5 degrees C for the thorax. Assuming that thorax length is a better estimate of body size, it is not possible to state that increasing the temperature results in monotonically decreasing size (the temperature-size rule), although this is often seen to be the case for genetic variations in latitudinal clines. The variability of the traits was investigated at two levels-within and between lines-and expressed as a coefficient of variation. The within-line (environmental) variability revealed a regular, quadratic convex reaction norm for the three traits, with a minimum around 21 degrees C. This temperature of minimum variability may be considered as a physiological optimum, while extreme temperatures are stressful. The between-line (genetic) variability could also be adjusted to quadratic polynomials, but the curvature parameters were not significant. Our results show that the mean values of the traits and their variance are both plastic, but react in different ways along a temperature gradient. Extreme low or high temperatures decrease the size but increase the variability. These effects may be considered as a functional response to environmental stress.
在法国南部对黑腹果蝇的一个自然种群进行了为期三年的采样,每年的样本中调查了10个同雌系。测量了两个与体型相关的性状,即翅长和胸长,并计算了翅/胸比率。在12摄氏度至31摄氏度的七个不同恒温条件下发育后,分析了表型可塑性。三年的样本表现出相似的反应规范,表明自然种群中存在稳定的遗传结构。使用导数分析,用整个样本(30个品系)精确确定每个反应规范的形状。实际结论是,在所有情况下都可以使用多项式拟合,但程度不同:翅/胸比率用线性拟合,胸长用二次拟合,翅长用三次拟合。翅长和胸长均呈现凹形反应规范,在可行的温度范围内有一个最大值。然而,最大值出现时的温度差异很大,翅长约为15摄氏度,胸长约为19.5摄氏度。假设胸长是体型的更好估计指标,那么不能说温度升高会导致体型单调减小(温度-体型规则),尽管在纬度梯度的遗传变异中经常出现这种情况。在两个水平上研究了性状的变异性——品系内和品系间——并表示为变异系数。品系内(环境)变异性显示,这三个性状呈现规则的二次凸形反应规范,在约21摄氏度时最小。这个最小变异性温度可被视为生理最适温度,而极端温度则具有压力。品系间(遗传)变异性也可以用二次多项式拟合,但曲率参数不显著。我们的结果表明,性状的平均值及其方差都是可塑性的,但沿温度梯度的反应方式不同。极低或极高的温度会减小体型,但会增加变异性。这些影响可被视为对环境压力的一种功能反应。